Search results

  1. R

    Rope Stuck on Evinrude 6HP outboard

    Perhaps the motor was submerged and not recovered / treated promptly.----The bearings / crankshaft could then be rusted badly.-----Woul;d need a complete teardown if that is the cae.-----Not worth taking this 77 / 78 / 79 model to a shop for that level of work.----Your location ?
  2. R

    Rope Stuck on Evinrude 6HP outboard

    Answer questions after CAREFUL reading.----Does the flywheel turn a wee little bit ?----Or is it absolutely stuck with no movement whatsoever.
  3. R

    1974 Evinrude 115 hp 2 stroke

    Your location ?
  4. R

    Reeds?

    Then with new reds it should start even quicker.
  5. R

    Reeds?

    Install a used ---Johnson / Evinrude electric primer valve.----Then hard starting will go into the history book.
  6. R

    Rope Stuck on Evinrude 6HP outboard

    ????----Can you turn the flywheel ?
  7. R

    Lund 315 new to me - now what do I do?

    You can start it up the way it is.-----If it starts / runs replace the impeller.
  8. R

    90hp outboard died suddenly, wouldn't restart

    Nobody can see or touch your motor !-----Do some trouble shooting / answer questions to come up with a happy ending.
  9. R

    Evinrude big twin 40

    Best to look after that electric shift gearcase.-----New seals are cheaper than the springs , clutches and gears.
  10. R

    90hp outboard died suddenly, wouldn't restart

    ???----When / if one carburetor is plugged you might be starving one cylinder of fuel and OIL !---Serious damage mat occur.--These motors in good condition start right up.-----Load tested the battery?-----Pushing the key in and holding it in while cranking it over for cold starting ?-----Oil...
  11. R

    Ugly Impeller

    Factory impeller ?-----Or something else.----Sure looks like it was run dry a few times.
  12. R

    Evinrude big twin 40

    Could be tiny air bubbles.----Let sit for 3 days and check.
  13. R

    Evinrude big twin 40

    Are you checking gear oil 1 hr after your trip or 3 days after your trip ?
  14. R

    75 hp Evinrude issues

    Those may have used a wee box with relays.-----That was mounted inside the boat.----Later models had it mounted up above the carburetors.----Your location?
  15. R

    Confusion in Evinrude ID for E75TLCRD

    T----Is for trim / tilt.----And I do not believe the 75 HP model was ever offered with a tiller.
  16. R

    1971 Johnson 85hp carb options

    Yes ---They fit.
  17. R

    115 Etec gearcase assembly

    Replacement pinion MUST be shimmed to the lower driveshaft.-----Where bearings cleaned of any / all metal chips ?
  18. R

    Need help with my prop

    Is there foam under the floor?---Possibly soaked with water?----What is the pitch on the prop that you have now ?
  19. R

    96 Johnson 28SPL lower unit interchange?

    Need to find a better shop ~~----Oil fill washers are the same from 1950 to 2020. -----Gearcase from any of the 28 HP model will fit.----Years 1986 to 1997.
  20. R

    2000 Johnson 60 HP

    Information must be posted.------What pitch prop?---What boat?----Does spark jump a gap of 3/8" on each lead?----Actual compression values.----Does timer base rotate fully?----Flywheel key checked?----Run with timing light ( one cylinder at a time ) to see if there is a spark issue.-----Shine a...
Top