Search results

  1. Scott Danforth

    Volvo Penta Leaking water.

    when was the last time you pulled the drive, inspected the bellows? checked the u-joints? alignment?
  2. Scott Danforth

    Forester Boat

    you are sitting on a project that will cost you to dispose of, or you can dump a lot of money into restoring it. (all fiberglass boats older than 15 years should be considered a project until proven otherwise) someone may want it. however you may not be able to sell it without a title (local...
  3. Scott Danforth

    No water out of exhaust.

    I wouldnt remove the thermostat. it is used as a mixing valve on I/O's without it, the block gets too much water flow and the exhaust doesnt get enough.
  4. Scott Danforth

    No water out of exhaust.

    at low speeds and the low water flow of a hose while on the muffs, most of the water will come out the idle relief ports. most likely the bit of plastic is what is left of your flappers
  5. Scott Danforth

    '89 Arriva 2050 Restoration

    I normally worked with teh shop vac hose near the discharge of the grinder. however dust does get everywhere. a few things I learned to keep the dust at a minimum: new bags nearly every day to maximize the shop vac air flow use your leg to hold the hose next to the grinder head work away from...
  6. Scott Danforth

    Lost All Steering on Bravo 3 Outdrive

    factory service manual would be where I would go for a rebuild
  7. Scott Danforth

    Lost All Steering on Bravo 3 Outdrive

    get an a-frame gantry to pull the motor. if you can turn a wrench, you can do this. (hint - buy the gantry used off craigslist or marketplace, use it, then sell it when done.)
  8. Scott Danforth

    Help me identify whether I have a 1" or 1 and 1/8" shaft

    Open tool box Grab 1" wrench..... Does it fit over shaft?
  9. Scott Danforth

    Mercruiser 3.0 overheated, Is my motor shot?

    Besides the compression test, to check motor health, all the rubber bits in the exhaust needs replacement. You burned the flapper and the rubber couplings when the exhaust went from 220 with water to 1000 without water I would also pull the lower and see how bad you toasted the raw water pump...
  10. Scott Danforth

    bastardized1993 Mercruiser ski mag oil change question

    measure the dipstick, measure the tube. the oil level is 3.5" under the top of the pan rail
  11. Scott Danforth

    Insurance

    you have to call around. start with your current agent
  12. Scott Danforth

    Is it normal for trailer tires to wear unevenling?

    only the original poster is allowed to revive old threads.
  13. Scott Danforth

    What is this connector and bracket? Fishfinder/GPS/etc.?

    looks a lot like my old hummingbird. not worth the effort to try to save them. get a new depth finder/sonar/etc and replace it.
  14. Scott Danforth

    Pressed-in Zerk grease fittings

    there are also metric threaded zerk fittings. would you pay $20 per hub more for the trailer?
  15. Scott Danforth

    Pressed-in Zerk grease fittings

    True, the $0.10 difference in the fitting, the $0.40 difference in the hub machining, about $1 less labor is a small amount at the front end........ The cost difference at the end of the day once the trailer is built, shipped , sits in the dealers inventory, (with all the compounded interest...
  16. Scott Danforth

    Takes on water over the transom while loading and unloading

    the splash well should prevent water from entering the boat, unless someone removed it.
  17. Scott Danforth

    Short vhf antenna

    remember, short antennas are pretty much useless for reaching any distance. for VHF, you want the tallest antenna you can afford. the longer the antenna, the greater (higher) the gain that mount allows you to fold the antenna down when you put the cover on.
  18. Scott Danforth

    Boat will run perfect in neutral and will rev up in neutral but will die instantly

    @Grub54891 volvo penta does not use a shift interupt switch, they have a cone clutch @timmy262003 your motor will rev to 5000 RPM in neutral running on 2 cylinders being fed by a drop of fuel. however under load you need all 6 cylinders being fed a lot of fuel. what is the story behind your...
  19. Scott Danforth

    Old Mercruiser 120 3000rpms WOT rated for 3900-4300

    your motor is designed to run on 87 octane fuel from the local gas station. adding octane booster will do nothing but lighten your wallet and lose a bit of power unless your motor is designed with really high compression, you do not need high octane. your motor is NOT designed with high...
  20. Scott Danforth

    Time to redo the back deck vinyl/upholstery - what brand/kind to go with?

    the sunbrella line of vinyl fabrics have the longest waranty against pinking in the industry the teflon threads are probably the best for UV
Top