Search results

  1. Alumarine

    A/C unit hose

    Could use a utility knife to cut a slit in the hose to get it off. If you spray Quicksilver Powertune on the barb it might help the new hose slide on.
  2. Alumarine

    How to replace trim switch????

    Welcome. If that control is like mine on the bottom of the control handle there was a gap where I inserted a hex key. If you put it full throttle in throttle only mode then the gap would face the stern and make it easier to look at.
  3. Alumarine

    2001 Trophy pro 2103 radio harness

    Welcome. Trophy doesn't make radios. If you can figure out what make and model the radio is then that might help to get a connector. Otherwise, splicing is your best bet.
  4. Alumarine

    Electrical 2008 Avalon Pontoon

    Welcome. I'm afraid you're going to have to follow them to see where they go.
  5. Alumarine

    Batteries status after winter storage

    I trickle charge mine a couple of times over the winter. But, if it's a good battery that is fully charged they can have a full charge without charging. Helped a friend get his boat ready last week. He left his 3 year old battery in all winter with the boat outside. We had about a month of -22F...
  6. Alumarine

    Mercruiser 3.7 MCM 165 not getting to operating RPM

    Welcome. Is the the new drive the same gear ratio as the old drive? Is the new prop the same spec's as the old one? The gear ratio should be 1.84 approximately. A change in either will impact rev's.
  7. Alumarine

    Mercruiser 3.0 tks noise at idle or no wake speed

    Yes, that's correct.
  8. Alumarine

    Mercury 1150 Stuck in UP position

    Welcome. You might have to crack the hydraulic lines to get it down. The Reverse Lock Control knob only allows you to tilt the motor up, it will not help with getting it down.
  9. Alumarine

    Mercruiser 3.0 tks noise at idle or no wake speed

    Welcome. All I can suggest is taking the drive belts off and see if the noise is still there? Not that it has anything to do with the noise but what's with the loose black wire with the ring terminal at the back of the motor?
  10. Alumarine

    Power Trim Up not working

    You're correct. The Trailer up just raises the drive higher than the Trim button. Yours is a common problem and many people use the Trailer up instead of Trim when the Trim function fails.
  11. Alumarine

    1996 Bayliner 1952CN, won't start after winterization - new boat owner

    The choke should be almost fully closed when trying to start a cold motor. Approximately a 1/8" open gap. That's after pumping the throttle a couple of times and having the throttle advanced a tad.
  12. Alumarine

    5 hp 4 stroke has water in oil.

    How much water? Did it look like chocolate milkshake?
  13. Alumarine

    1996 Bayliner 1952CN, won't start after winterization - new boat owner

    The flame arrestor is the square cover on top of the carb. It does not need to be on for testing purposes. Just keep your face away from the top of the carb when trying to start it. Not sure what you mean by the aluminum can. Here's a couple of pictures that show what a choke looks like. They...
  14. Alumarine

    1996 Bayliner 1952CN, won't start after winterization - new boat owner

    Welcome. Try giving it full throttle after pushing the throttle only button. Then start cranking for a bit. Get ready to pull the throttle back if it starts.
  15. Alumarine

    1972 glas_ply need help with power tilt lines

    What dubs283 said. Also, it's best to use a good quality flare nut wrench so you don't strip the fittings. Might want to tie a line to the old hose, pull the old hose with the line out and then use the line to pull the new hose in place.
  16. Alumarine

    Stingray 208cr trimtabs question

    They can help get you on plane quicker. The have 5 adjustment holes. You can adjust them so they are up higher and then see if it planes quick enough for you.
  17. Alumarine

    Just purchased the new Lowrance HDS9 Live Fish Finder, I have a transducer question.

    Sometimes you have to fine tune the location, angle etc so they work at speed.
  18. Alumarine

    Is E-10 Fuel Acceptable Early in the Season?

    I buy whatever is on sale. Last time it was Walmart Supertech.
  19. Alumarine

    Is E-10 Fuel Acceptable Early in the Season?

    I've always run E10 all year long. If I think of it I put in non ethanol for the last tank of the year. Often the season ends and I still have E10 in it. Never had any issues. I do put stabilizer in the last tank for good luck.
  20. Alumarine

    To fuel filter or not. 3.0

    What documents are these? I've had them on 3.0's for years and they work fine.
Top