Search results

  1. R

    Evinrude Tilt Trim motor

    After the tilt cylinder goes to maximum extension , the trim cylinders may start to move.----Sounds like you need to contact the seller on this trim / tilt unit.
  2. R

    Have spark and fuel, can't get the rebuilt engine to start

    Not an expert here, but is there a mix up with left hand / right hand rotation parts ??
  3. R

    1975 Johnson 25 won't run above idle in gear under a load.

    Some simple inspections to do on your part.
  4. R

    1975 Johnson 25 won't run above idle in gear under a load.

    ????-----" forward gear won't go above high idle "----That statement could mean different things to different people.----Could be many things to check.-----Motor might be running on 1 cylinder for any number of reasons.------I should refrain from giving simple advice on this one.-----Stepping...
  5. R

    1975 Johnson 25 won't run above idle in gear under a load.

    Maybe the propeller is slipping ??
  6. R

    Info on Evinrude 115 E115TLETS

    When they assemble a new motor is with hundreds of tested / inspected parts.----No different when you are inspecting / refurbishing a motor that is 30 years old.
  7. R

    Suggestions rebuilding a Bowrider

    You are looking to build a bow like in the pictures for your own boat?
  8. R

    1956 Fastwin 15 Drive Shaft and Impeller Issues

    The pin at the top of the driveshaft rotates / drives the seal assembly.
  9. R

    1956 Fastwin 15 Drive Shaft and Impeller Issues

    ????----On the 5.5 HP there is a hole for a pin / key to drive the impeller !------Not possible to install driveshaft upside down on a 56 model 15 HP.
  10. R

    Confused New Owner of an Old Boat

    Looks like it had water in it and froze.------Gear housing needs to be replaced.
  11. R

    Confused New Owner of an Old Boat

    That is correct.----A GM inline 6 model.------Many ( not all ) had issues with structure under the floor.----Boat appears to have been looked after.
  12. R

    Info on Evinrude 115 E115TLETS

    Start another --" oil thread "----On the fundamental difference between TCW oils and oil meant for direct injection engines ?
  13. R

    Info on Evinrude 115 E115TLETS

    I see post #17----I am not sure why the comment about---" Absolutely makes an injector oil " ----is even in that post.-----I am just curious as to what is meant by that comment
  14. R

    Oil coming out of carburetor

    See post #10
  15. R

    Info on Evinrude 115 E115TLETS

    Not sure why this was mentioned in post #17.----The statement does not make sense to me.
  16. R

    Oil coming out of carburetor

    How did this motor run for you last season?
  17. R

    Oil coming out of carburetor

    One way for gas to get in the oil is via a defective fuel pump.----Oh --these 4 strokes with all their hidden issues.
  18. R

    Oil coming out of carburetor

    Was the motor stored properly?---Laid down in wrong side perhaps ?
  19. R

    1956 Fastwin 15 Drive Shaft and Impeller Issues

    Pull lower unit apart.----Some pinion gears use a circlip to position the driveshaft.----Clip might be missing / broken or rusted away.
  20. R

    Confused New Owner of an Old Boat

    Post pictures of the damaged / cracked housing.----Only way to get accurate opinions on repairs.
Top