Search results

  1. R

    25hp evinrude outboard

    Or was it 1985 for the thru hub for the 25 HP ?
  2. R

    Evinrude 25hp outboard wants to die when I give it gas

    A 1953 model , or 73 , 83 . 97 or 2004 model ?----Does spark jump a gap of 5/16" or more on all leads ?-----Post the actual compression test values.
  3. R

    J30JRSIE 30 hp Outboard - Carb Question

    Does spark jump a gap of at least 3/8" on both leads ?-----Post the actual compression test values.
  4. R

    My new “old” Larson bowrider

    ???----To me it looks the bulkhead was cut out.-----Left over fiberglass tabbing is clearly visible.-----It was not repaired the be the same ( or better ) than when it left the factory.
  5. R

    My new “old” Larson bowrider

    The 4th picture shows repair work .----But seems the bulkhead was not replaced and the same as original.-----In the GTA area ???
  6. R

    Stalling at Idle and Idle Speed

    Test run with another tank and hose.-------Bulb does NOT need to be hard when motor is running.-----Sounds like a small air leak on fuel system------Fuel pumps run off the crankcase compression pressure.-----There may be issues there.----Posting cylinder compression values can help with...
  7. R

    Steering seized?

    Try turning the helm and see if it turns easily.-------If this is a G2 model it is " fly by wire ".-----Needs to be running and steered by helm I think.
  8. R

    1988 Merc 115 inline 6-Rough in low gear only after WOT

    Running with back drag on carburetors ?----What elevation ?---Might be as simple as opening low speed mixture screws 1/8th turn at a time.
  9. R

    1st Boat

    The older V-4 with new O/S pistons will run for many years.----Just had someone complement my work on a 1990 V-4.-----Had it for 13 / 14 years and it ran good when they sold the boat.
  10. R

    1977 Johnson 140 can’t turn over

    Some want to argue.------Here I would take the starter apart to determine the condition.----Easy to do and costs no beer tokens.
  11. R

    1977 Johnson 140 can’t turn over

    No such thing as too much compression / suction / back pressure in my opinion.-----Can you or a strong teenager pull this motor over with a rope on the flywheel ????----Was the crankshaft out ???----If so was the center bearing lined up on the dowel pin ?
  12. R

    1978 Mercury M-800 starting issues

    Well, yes the exhaust could be plugged with a mouse nest.-----But pull it over with a rope on the flywheel as a test !
  13. R

    1994 Mercury 40HP 2 stroke outboard overheating

    Metal cups in water pumps are all off center !
  14. R

    1st Boat

    But it all depends on whether you can find a shop that is willing to work on Evinrudes.-----I know of a shop that bought all the new spare inventory of Evinrude parts from another dealer.----That dealer is now saying no to every Evinrude service enquiry I guess.
  15. R

    1977 Johnson 140 can’t turn over

    Bad starter.---Bad lower unit, checked the oil ??--Bad solenoid ?--Bad cables?-----Bad bearings in engine.------Simple test, can you ( or neighbor ) pull it over with a rope on the flywheel?-----Should be easy to figure out.
  16. R

    Mid1980's Mercury 2cyl 35hp Spark Plug Question

    Just marketing 101 in my opinion-----Plus the legal aspects of dealerships and aftermarket parts marketing,-------Sort of like GM and AC-Delco
  17. R

    1978 Mercury M-800 starting issues

    I guess I missed the part about the 3 starters.----Good luck with your motor.
  18. R

    Mid1980's Mercury 2cyl 35hp Spark Plug Question

    I think " Quicksilver " is the brand name for Mercury accessories.------Such as oil , props and repair kits.
  19. R

    1978 Mercury M-800 starting issues

    Take the starter apart for inspection.----Load test the battery.----Inspect battery cables.
  20. R

    Intermittent spark on 1976 35 HP Evinrude

    Sounds like it was rust.----I doubt that was the issue in this case.
Top