Search results

  1. alldodge

    Bravo one Transom Assembly hole

    Use screws and tap holes
  2. alldodge

    Trailer Jack Upgrade to Air-Filled Tires

    For a light trailer it's good
  3. alldodge

    Which ECM

    Look on the back of it for a part number
  4. alldodge

    Raw water pump casing

    It should be flat but a 0.015 variance over full surface with rubber doesn't seem to be an issue. Hey @kenny nunez
  5. alldodge

    Bravo one Transom Assembly hole

    That will work
  6. alldodge

    2000 Volvo Penta 5.7 Gfi with no spark

    Yes I was wondering about the diagnostic cable Seeing the boat wiring, also agree there is some problems
  7. alldodge

    I have Faria Tach not displaying hours

    Probably a bad connection but.... What is your serial number?
  8. alldodge

    Mercruiser 120 starting stumped?

    For oil and water going into the bilge I would say busted block
  9. alldodge

    2000 Volvo Penta 5.7 Gfi with no spark

    Show pic of your cables
  10. alldodge

    4.3gi no start new ICM. how to set base timing?

    No, no kind of cranking will induce water in the cylinders No Kind of, sort of Intake crack can induce water into oil, but will not be slow My opinion You need a Mechanic to look it over, the process of DIY is a bit beyond the current understanding right now
  11. alldodge

    1981 120 Mercruiser idles rough when hot

    It's most likely fuel related, either not enough or to much. When it stumbles look down throat of carb to see if it appears to be flooding. If no flooding, need a fuel pressure gauge and Tee fitting. Measure pressure at the carb
  12. alldodge

    Mounting a gen 1 alpha to a gen 2 housing.

    Guys ya'll are hyjacking the thread
  13. alldodge

    Starter options for 2000 5.0 GL?

    They seem to be fine, my self I buy API 10105 which is around $150
  14. alldodge

    Maxwell 500

    I would say it's the relay/solenoid. Had a 500 on my 94 Formula and never had the first problem in the 20+ years I owned it
  15. alldodge

    1995 Mercruiser 350 No Start

    Fuses will be close to the ECM and will either be individual or both together. In any case the fuses will have black caps over the top of the fuse. Look for black rectangular item with wires on one end. Check for 12V at the coil with key ON and when cranking
  16. alldodge

    2000 Volvo Penta 5.7 Gfi with no spark

    With a lot of codes look at the 5V circuit to see if you have exactly 5V. If lower then one of the sensors is bad. Try at looking for gray wire on throttle position or MAP
  17. alldodge

    Is this trailer repairable?

    It can be fixed, just depends on cost Most likely there is more issues they just are currently unseen
  18. alldodge

    Maxwell 500

    If it's an anchor windless (I had same model) then most likely its the relay which is normally close to the windless. Can also be the helm switch has issues or bad connection
  19. alldodge

    4.3gi no start new ICM. how to set base timing?

    With new plugs fowling, put the old injectors back in
  20. alldodge

    4.3gi no start new ICM. how to set base timing?

    Many list injectors as rebuilt and for the most part, electrical injectors can not be rebuilt, they can be cleaned up to look great. The injectors are standard GM type, but we can let this one go for now Was running rough and now it won't even start after replacing the ICM. Have you tried...
Top