Search results

  1. dingbat

    transducer routing question

    A 20th century concern....... If your wiring is so jacked up it interferes with a shield transducer cable you have bigger issues to worry about.
  2. dingbat

    Running wires under hull

    Guessing it was either the pivot tube for a speedometer or a hose for a water pressure gauge
  3. dingbat

    Transducer Anti-fouling Paint

    Can I apply Interlux antifouling paint to my transducer? Yes, it is recommended that you use a hard antifouling paint that does not contain ketones. Ketones are found in vinyl-based antifouling paints like Baltoplate and VC Offshore. A good antifouling paint to use is Fiberglass Bottomkote or...
  4. dingbat

    Transducer Anti-fouling Paint

    Water based formulations only https://shop.mdramazon.com/TRANSDUCER-PAINT-MDR-720.htm
  5. dingbat

    Sell Electronics With Boat or Separately?

    Agree......Loran-C is museum value only at this point.
  6. dingbat

    Trim tab installation over bottom paint

    Nothing good can come from installing the hinges over paint. I could be wrong, but I’m pretty sure the installation instructions don’t call for sealant between hinge and hull. Just 30 minutes marine epoxy on the mounting screws. Use 4200 under the cap...
  7. dingbat

    Running wires under hull

    You should have a dedicated wire conduit in there somewhere Do you not have one?
  8. dingbat

    Sell Electronics With Boat or Separately?

    Unless commercial or high end, used marine electronics are not worth much. Leave them on the boat as selling points
  9. dingbat

    Help me understand how to wire a shoreline float switch....

    I would strongly recommend wiring the pump through a 3 way switch given past experiences. Float switches, bilge pumps and the associated wiring are known problem areas. Floats stick, pumps burn up and wiring fails over time. It’s not if, it’s when there is a failure The last float that stuck...
  10. dingbat

    Help me understand how to wire a shoreline float switch....

    Float ground goes to the battery. Power is supplied via a 3 way bilge switch.
  11. dingbat

    Can't seem to find a big enough fuse block

    Not properly sizing the wiring is what gets people into trouble in this excerise. The 18 circuit block is rated to 100 amps. The 6 circuit is 100 amp as well 1. Wiring to fuse blocks should have no more than a 3% drop. 2. Length of wire from source to fuse block and back to source = X Not...
  12. dingbat

    Can't seem to find a big enough fuse block

    No problem daisy chaining the two blocks together if the wiring is sized correctly.
  13. dingbat

    Question on vents on Starboard side of boat

    They are either drains or intakes. Thru hulls can be threaded or have hose barbs. I had both when I replaced mine with stainless steel a few years back
  14. dingbat

    Question on vents on Starboard side of boat

    Plastic thru hull fittings that have deteriorated from UV exposure and broke off. Strongly recommend you replace every thru hull on the boat. Many a boat have sunk as the result of a failed thru hull
  15. dingbat

    2000 200hp saltwater series lost fuel prime

    No.....the anti-siphon valve is typically built into the fitting where you connect the fuel line to the tank. Bear in mind that this can only be a problem if you have a leak (vacuum) somewhere in the fuel system.
  16. dingbat

    2000 200hp saltwater series lost fuel prime

    Check the anti-siphon valve. If it sticks open or is missing, a leak upstream will allow the fuel to drain back into the tank
  17. dingbat

    Great time to sell a used boat.

    This is pretty much true no matter what price you buy at. Good reason to keep a years worth of expenses in the bank at all times.
  18. dingbat

    Mercury 115 CT 2.1l Bay star steering good ?

    The displacement of the helm determines the speed (flow) in which the cylinder reacts and force (pressure) applied to the cylinder. Increasing the hose size does nothing to increase the flow and will actually reduce the pressure applied to the cylinder. The additional fluid inside the larger...
  19. dingbat

    Great time to sell a used boat.

    People typically buy home on loan payments, not price. If the bottom where to fall out of the market tomorrow, they may loose some equity but their payments will go unchanged.
  20. dingbat

    Mercury 115 CT 2.1l Bay star steering good ?

    Sea Star is for outboards 150+ HP. Over kill for a 115 HP Over sized hoses buy you nothing unless you update the pump displacement of the helm as well.
Top