Search results

  1. 9

    Suzuki dt2 no spark

    old school was to use a business card between the magnet and the coil iron
  2. 9

    Yamaha 2 stroke crank bearing, to grease or not to grease?

    put some straight 2 stroke oil on it if you want to protect it until it is sealed up and a running motor
  3. 9

    Yamaha hpdi 200 crank, no start

    just curious, what does PBT mean
  4. 9

    1996 Yamaha 9.9hp 4 Stroke Tiller motor

    Ts are 4 stroke also
  5. 9

    1996 Yamaha 9.9hp 4 Stroke Tiller motor

    Is that a T9.9 or a F9.9 T stands for high thrust, so it is geared lower to push a bigger prop may make a difference for what you want to use it on
  6. 9

    Fuel pouring from hood?

    it does not take a lot of mechanical know how to look to see where the fuel is coming out of when it is leaking. so you know what needs to be done to fix it
  7. 9

    1996 Yamaha 9.9hp 4 Stroke Tiller motor

    I thought that far back in years the motors cost about $100 a HP no warranty on a 26 year old motor, so you take you chances
  8. 9

    Fuel pouring from hood?

    to start out, you are going to need to pop the hood and inspect to see where it is coming from. good chance your fuel tank is pressuring up (not venting)during the hot days any leak in the fuel system will then be leaking fuel out because of the tank pressure
  9. 9

    Hooked up battery backwards to yamaha 70 etlj 1986

    looks to be neutral start switch. should be easy to test with an ohm meter when disconnected or voltmeter when hooked up and turning the key to start. should allow starter to engage only when in neutral
  10. 9

    2003 Yamaha 150 Salt Water series

    My thoughts are burnt contacts inside the T&T relay not making good contact every time
  11. 9

    can't remove lower unit from Yamaha 9.9 high thrust

    thanks, for posting that info. I am sure some others will like to read about how you got it done
  12. 9

    can't remove lower unit from Yamaha 9.9 high thrust

    how did you get it off? Someone else having this problem would welcome the info somewhere down the road. even pics would be good
  13. 9

    Trim@Tilt locked in the up position.2005 150 2stroke

    are you saying the tilt and trim motor runs but does not operate the tilt and trim hydraulic system to lift the outboard motor? and are you talking about the screw(manual release) that Boscoe is talking about
  14. 9

    Steam out of tell tale

    sounds like a blown head gasket or crack that lets combustion gases into the water jackets . leak down test with compressed air should indicate that
  15. 9

    Yamaha 50 HP Idles to 3000

    you will need to look at the carb throttle plates to see if they are closed when this high idle happens. if they are closed when they should be at idle, then I would monitor the timing with a timing light. advanced timing could bring the idle up
  16. 9

    Warning buzzer

    what did your gauges tell you? overheat? stats, pressure relief valve, or pump need attention possibly
  17. 9

    Orange spark, no start

    rail pressure in spec would be my 1st thought, but with the proper software and computer hook up
  18. 9

    Yamaha 150 Throttle issue

    no one knows what motor you are talking about , maybe not even you so you did not share that info. I guess since it is around 3 years old it maybe a F150 fuel injected motor. inspecting plugs and monitoring rail pressure would be a start. I see no reason linkage could cause this unless the...
  19. 9

    Yamaha serging

    maybe an air leak in fuel connections on suction side of fuel pumps. not enough fuel getting to carbs
  20. 9

    Water Pump Base Removal C90 Yamaha 2 Stroke

    well that is a little late right now since you have already gotten it taken care of, but make sure you post the motors info next time you start a thread asking for advice
Top