Search results

  1. Scott Danforth

    Fuel Transducer Location?

    your steady state operation will be accurate enough your transient operation will be averaged by the fact you have a carburetor the fuel flow meter wont be affected if its mounted 2 ft away, or 20 ft away from the carb.
  2. Scott Danforth

    Mercruiser or volvo

    Mercruiser quit using GM motors in 2015, making their own 4.5 liter V6 and 6.2 liter V8 motors in-house . Volvo Penta still uses GM motors. as far as drives go, the Alpha drive uses a dog clutch, the Bravo drive uses a cone clutch Volvo only uses cone clutches If looking at new, spring for...
  3. Scott Danforth

    Boat plumbing

    Plastic thru-hulls last about 15 years. Your boat is 29 Boat builders barely document the boat. Plumbing, wiring, and rigging is done by trained folks. However schematics never existed
  4. Scott Danforth

    Water Intrusion Puzzle

    Most probable sources of water intrusion: Failed exhaust elbow gasket Cracked block/heads from improper winterizing Cracked block/heads from overheating
  5. Scott Danforth

    Springbok wiring

    Trace the wires and compare the wire colors listed in the electrical forum stickies, and hope the boat was wired to the ABYC color code
  6. Scott Danforth

    Overheating Volvo Penta 4.3 L

    Did you check the raw water inlet fitting on the drive?
  7. Scott Danforth

    76 OMC 175 starting

    Running in a tote won't work as the raw water pump is just below the driveshaft above the split The tote has to be big enough to submerge the whole drive, which requires the tote to be the size of the boat
  8. Scott Danforth

    Electric boat maker shutters plant in WV

    Companies like Cummins have a fleet of hydrogen trucks, boats, and off-highway equipment including gensets that have been running around for almost a decade Hyundai and Toyota have hydrogen vehicle offerings I would rock a hydrogen fueled boat and not look back
  9. Scott Danforth

    4.3 Chocolate milk

    How did you winterize? If you sucked antifreeze with a blockbuster kit, you killed the motor
  10. Scott Danforth

    95 502 needs help

    New doesn't mean good
  11. Scott Danforth

    76 OMC 175 starting

    Because your ground cable is corroded..... Replace it
  12. Scott Danforth

    Putting things back on the boat

    3M 5200
  13. Scott Danforth

    Banging

    What was the last time the drive was pulled for annual PM?
  14. Scott Danforth

    '85 Sierra 16.5' Fiberglass - Floor / Transom / New Layout

    Keep grinding up the sides, about 8" past where you will tab
  15. Scott Danforth

    76 OMC 175 starting

    as mentioned above..... NO. its the opposite. the points are what open and close to energize the coil primary side, then allow the magnetic field to collapse allowing the secondary side to fire. without servicing the points, is expecting a toaster to work when its not plugged in. with...
  16. Scott Danforth

    76 OMC 175 starting

    Did you service the points?
  17. Scott Danforth

    1984 CVX20 Ski machine service manual

    The only legal place to get a new factory manual. https://outboardbooks.com/
  18. Scott Danforth

    Evinrude Sportwin 9.5hp Pinion Gear

    Any johnnyrude dealer can sell you parts
  19. Scott Danforth

    2008 bayliner 192 discovery

    5100 RPM. Rev limited to 5150 Most likely your tach is simply on the wrong setting
  20. Scott Danforth

    New Rescue Boat???

    Are the shallows rocky where you need the jet? Is there skid plates on the bottom like most shallow water jet boats? Some tunnel cats will run in 2" of water as well as a fair amount of chop. I remember there is a tunnel cats RIB that runs a jet that was designed for rescue. Can't remember...
Top