Welcome John
For the most part wire is wire and it doesn't care if it has 12 or 24V. What does make a difference is the amount of current (Amps).
Determine what size (gauge) wire feed motor now. What size fuse is on the motor. Look for specs on current motor and see max amp draw and should...
Any can do it
To do a compression test, pull plugs and attach Compression gauge
Open throttle wide open and crank motor over at least 4 times and record reading. Remove gauge and move to next cylinder and repeat until all have been tested
Remove drain plug slightly just enough to see if any...
Foam doesn't provide increase in buoyancy, the size of the hull does. The foam is used to stiffen the structure and can keep the boat from sinking to the bottom if swamped, but this depends on hull design and amount of foam.
The boats weight limit is there for safety. A overloaded boat can...
there is not an option
If you see a thread without many comments just means there was not much interest. You can start your thread with please don't comment, or I don't want to read one comment, go away and see if that works
Maybe do your entire project and keep all info offline. Then real...
Wife has had the "do touch anything call Microsoft at number below" many times by clicking the wrong thing on FB
Luck she now knows how to get out of it and resume
Your missing most the fun. I let them come in to get their info. Once I have it I report to FTC under do not call list and it cost them 1,500 bucks each yime
Have Dish and from time to time have received calls which ask if I want to upgrade and always say no. They are always from India and ok, nothing ever happens
Get a call today asking for the receiver info and they want to verify what they have. I give them the info from the TV. Then the guy...
The rams are self bleeding. Raise and lower a few times and, and so long as the fluid stays up in the pump and does not foam, your good to go
The ram is a simple hydraulic cylinder and has internal seals to keep oil on each side without leaking. Over time seals wear out and they can start to leak
If leg drops any when raised by the pump and there is no oil leaking inside or outside the boat, then the leak is internal. Most likely cause is the trim rams and rebuilding them is easy
