Search results

  1. Scott Danforth

    oar lock bushings

    uhhhh,..... hence the link in post #3 to the flanged bushings of the size the OP was looking for in post #1
  2. Scott Danforth

    what to use to line ski locker

    this is along the lines of what was in my searay. https://www.walmart.com/ip/Chaparral-Boat-Non-Skid-Mat-HAR28GR-59-Ski-Locker-Gray-Rubber/1364016414
  3. Scott Danforth

    Outdrive cannot clean

    yes, and you need to neutralize the corrosion, then use an etching agent or an etching primer.
  4. Scott Danforth

    DIY - Canvas Enclosure

    Hey Ted, wanna make side and front curtains for another Cruisers....... I can send the patterns. ;D
  5. Scott Danforth

    Easiest engine drop in replacement for 1986 MCM 470

    yes, the 3.7 uses a GM flywheel bolt pattern same as 4.3. you do have to change the u-joint shaft. the 3.0 is under powered and nearly the same weight as the V6.
  6. Scott Danforth

    95 Four winns 5.8L OMC Cobra

    none of the fuel injection parts are available. so when it breaks, you have to convert to carb. Ford went out of the marine business about the time your boat was new. OMC went out of business probably as they were pushing your boat out the building. we normally tell people avoid ford and...
  7. Scott Danforth

    1998 Rendova 14 foot tender

    Just an FYI, most hypalon boats last a max of 20 years. yours is pushing 27
  8. Scott Danforth

    what to use to line ski locker

    When I had an early boat with a ski locker, I had glued in carpet that was changed to glued in urethane sheet. SeaRay had a light grey/off white rubber grid-like mat like you would find in a shower EVA (like seadeck) would probably work well. line-x works well too
  9. Scott Danforth

    VOLVO PENTA OUTDRIVE DROPPING INSTANTLY

    no, its generally not installed
  10. Scott Danforth

    Wrong year on title

    FWIW, my old SeaRay 190 was a late 2001 build registered/sold/titled in Wisconsin and then Florida as a 2002
  11. Scott Danforth

    Battery switch not starting on 1, starting fine on 2 and All

    Its up to you, I personally would sort it out before you become a headline in the Page AZ newspaper " boater body found, been missing for weeks"
  12. Scott Danforth

    Wrong year on title

    Have you contacted Michigan?
  13. Scott Danforth

    1973 mercruiser 120 HP no spark

    When did you add the pertronix? And has it ever run?
  14. Scott Danforth

    Are you ready to puke?

    Remember, the stringers rotted years before the floor. Long before plywood and screws, you need to build a cradle, buy a bunch of tyvek suits, and cut out all the rotten stuff and grind ... grind....grind
  15. Scott Danforth

    Trim switch wiring review

    the factory volvo penta drive service manual has a fantastic wiring and troubleshooting section in the back towards the index
  16. Scott Danforth

    Outdrive Pressure test Question

    You most likely have to contact them because they pulled the info for stuff 25+ years old a few years back There should be an email link
  17. Scott Danforth

    replace coupler or not?

    Those teeth are shot. Go to Napa and get a new ring gear
  18. Scott Danforth

    Mercury thunderbolt 110, no spark

    first, welcome aboard on a 2-stroke with magneto ignition, you ground the ignition to kill spark. that is what the kill switch does.
  19. Scott Danforth

    Outdrive Pressure test Question

    there are two prop seals. one facing inward to keep oil in, one facing outward to keep water out. the only place to get factory manuals if from volvo penta. https://www.volvopenta.com/en-us/your-engine/manuals-and-handbooks/ a haynes manual is only good if you run out of toilet paper or knee...
  20. Scott Danforth

    Battery switch not starting on 1, starting fine on 2 and All

    I would tend to think that your battery on #1 is dead or has a bad connection. have you had the battery load tested? are the connections clean enough for your mother-in-law to eat off them?
Top