Search results

  1. alldodge

    496 HO Failure

    Really, Really
  2. alldodge

    2002 Chaparral 286 SSI

    Don't change the prop unless it's not reaching WOT max RPM. A 3 blade prop is good, going to a 4 blade can help but also hurt performance. Need to know what current prop is doing and not doing before even thinking of changing
  3. alldodge

    Another prop slipping thread

    Use same coupler as removed, splines will be aluminum and should have squared edges not rounded or pointed.
  4. alldodge

    Another prop slipping thread

    Prop hub not spun Drive locks up and doesn't spin Only thing left is the coupler Remove drive and look at the coupler thru gimbal. Look to see if rubber has stripped mostly away from center. If drive doesn't slide off easy it's not aligned The extra hp is ok so long as the boat is light and...
  5. alldodge

    2002 Chaparral 286 SSI

    Welcome Chap is a good looking boat, but if the motor doesn't run it's a POS. Look after the motor and everything else is good
  6. alldodge

    Twin Merc V8 and different fuel usage

    Smart craft via can buss
  7. alldodge

    Twin Merc V8 and different fuel usage

    Don't know but probably not. Something worth looking into
  8. alldodge

    Twin Merc V8 and different fuel usage

    Thanks It probably is normal but the counter (port) burns less then the standard
  9. alldodge

    Twin Merc V8 and different fuel usage

    Motors have Digital controls, speed and RPM stay within a few RPM but the PCM. Both motors use electric power steering. Only thing that is different is port motor has a isolator installed to change house Bat
  10. alldodge

    1994 Regal Commodore 400 How to fix seacock leak thru hull

    Disconnect hose on seacock, remove seacock, then remove the thru hull. The thru hull should be sealed with 3M 5200 so there will some wood that will be damaged on removing it. Once thru hull is out, start removing any wood which is wet/damp. When all the wet wood is removed then it's time for...
  11. alldodge

    1994 Regal Commodore 400 How to replace fresh water tank

    Probably going to be hard to find someone who actually replaced the tank in the same model boat. Look under the AFT cabin bed and see if it can be determined.
  12. alldodge

    1993 OMC 5.8 EFI Idle problem, runs on throttle, too rich

    I don't think OMC can use Rinda, but could contact them for advice
  13. alldodge

    VOLVO PENTA 5.0 GXI Engine suddenly stalled after 10 minutes of running at 3000 rpm

    That's a new one, glad you found the issue
  14. alldodge

    Twin Merc V8 and different fuel usage

    Errr what ? Starboard CW, Port CCW Swap props so I run in reverse at cruise ?
  15. alldodge

    1993 OMC 5.8 EFI Idle problem, runs on throttle, too rich

    Sure wish we had more knowledge to help out
  16. alldodge

    12v boat hoist motor

    Thank you very much for updating Many folks will read this and your info will be invaluable
  17. alldodge

    Twin Merc V8 and different fuel usage

    2023 Merc 250 V8 Verado twin install on Chap 280 OSX Props are 19P Rev4 Does not have Axius but does have adaptive trim Idle shows fuel is same As power is increased the fuel burn on starboard increases and at cruise is mostly 1 Gal /hr more then port. Pretty much stays that way from 1000...
  18. alldodge

    Annual Mercruiser Maintenance

    So far I think your doing good More important is Replace drive lube, change oil, check alignment
  19. alldodge

    Mercury VesselView Mobile module

    Welcome Maybe @QBhoy can help
  20. alldodge

    Batteries will not hold charge

    Welcome Your charger isn't much if Bats are low. Charging 5 Amps to a dead Bat will take some time. Your Minn Kota 70 list max current draw is 42 Amps Blue top Optima Group 31 list 155 Amps @ 25 Amps, 75 Ahr. So the 2 Bats in series = 50 Amps. The 155 minutes / 60 = 2.6 hours at max. Your...
Top