Search results

  1. alldodge

    5.7 EFI stalls when warm and shifting into gear

    Agree You tested and it passed test, we don't have our hands on it so don't know if we can provide more info
  2. alldodge

    Carb. runs dry.

    Don't kow of a check valve but there is a antisiphone valve on the top of tak which the rubber fuel line is attached. If it's clogged it will stop fuel Do the diodes test high resistance in one way and low and no resistance the other way?
  3. alldodge

    Dean's List gets another motor

    And that is another part of the story We cranked until we were tired on the starboard side cutlass. Dean said he didn't see anything about not using a impact. So I brought out my Dewalt 20V impact. Man this was much easier Got it out and had trouble but managed to get the starboard side...
  4. alldodge

    Dean's List gets another motor

    We had a $400 tool (strut pro) which did the job but dang that is a lot of wrench turning, and it's hard work. I have a 3 ft 3/4 drive ratchet and 35MM socket (didn't have a 1 3/8 SAE). It was good we lifted it high enough to give us room to swing. Strut pro now makes a hydraulic type for 5K...
  5. alldodge

    Dean's List gets another motor

    Replaced the port side cutlass today. Hope I never do one of these again. Boat is ready to put back in the water, waiting for transporter to say when, wow almost a year.
  6. alldodge

    Spark plug crossover question

    Appears to be correct, but keep in mind this is a cross reference to be close to original https://www.sparkplug-crossreference.com/convert/NGK_PN/BR9HS-10
  7. alldodge

    Kohler generator cylinders keep hydro locking

    It doesn't diesel so not running backwards when shut down. Was the Gen fully warmed up and not still cold? If it was cold then it might not act the same. Best to see what it does after running a while with normal load the see if it does the same type of shut down. Dieseling is when a motor...
  8. alldodge

    Blogs plug housing loose and turns

    If it's rotten then its not going to get better Check the inside of the transom to see if it's soft. If soft how soft and how far up does it go. If its stays low around the drain maybe and short term fix. But it has to be pretty solid Get some 3M 4000 and get it good and dry then clean with...
  9. alldodge

    OMC Cobra hard to get in neutral

    Hey @kenny nunez have any ideas?
  10. alldodge

    Slave solenoid does nothing

    Unless the wiring has been changed the slave has to be working because otherwise how is the starter solenoid getting power to the Yel/Red wire
  11. alldodge

    Blogs plug housing loose and turns

    The tool to flare cost the most, I had to buy one to install 2 my self https://www.amazon.com/Flanging-Tool-inch-Drain-Tube/dp/B002MJDNV0/ref=sr_1_121?keywords=transom+drain+tube&qid=1690888548&sr=8-121 Could try and flare some more to seal or better yet, remove, clean, use sealant and reinstall
  12. alldodge

    Kohler generator cylinders keep hydro locking

    Well it's not a Merc so I moved it What happens when you shut the Gen down? Listen and watch to see what happens. Wonder if it diesels
  13. alldodge

    99 4.3 volvo gl

    Need to start with the basics Check for spark with a spark gap tester If you have spark, check for fuel Not knowing which GL it has I don't know which distributor it has
  14. alldodge

    5.0GXI Initial Timing Setup - Swapped motor.

    If motor has the flat type distributor cap then its not timed with a light This is for Merc but timing is the same
  15. alldodge

    CO2 issues

    Welcome If its in the bilge then sounds like gas fume monitor and not a CO detector If gas fume then can you smell gas?
  16. alldodge

    Mercruiser 4.3 MPI 262 CID s#1A34694Z NOT IDLING CORRECTLY SOMETIMES

    Thanks Your motor https://www.mercruiserparts.com/4-3l-mpi-alpha-bravo-0w658583-thru-0w6 The fuel rail fitting item 13, pressure should be 43 psi https://www.mercruiserparts.com/bam/subassembly/31503/13808/90
  17. alldodge

    Mercruiser 4.3 MPI 262 CID s#1A34694Z NOT IDLING CORRECTLY SOMETIMES

    Need a serial number Check the fuel pressure at the rail
  18. alldodge

    Mercruiser 350 mpi horizon 2007 max rpm 2500 today

    ok Throttle only button Motor number , look just above the starter for a plate
  19. alldodge

    Volvo Penta 5.0 GXI-E - Won't roll over

    Guess filter was installed without a bit of oil on gasket Strap wrench, or adjustable https://www.amazon.com/Adjustable-Filter-Wrench-Universal-Remover/dp/B09MMWTQ9Q/ref=sr_1_7?keywords=adjustable+oil+filter+wrench&qid=1690803380&sr=8-7
  20. alldodge

    My turn for a "New to me boat"

    What a story, good to find the main issue
Top