Search results

  1. alldodge

    Advise on starting a engine that has been sitting for unknown amount of time

    I think what your doing is good, don't know if the motor is rusted up or anything else With plugs out see if the starter will crank it over If it will crank over then see if it will start using a gas can. If it starts and runs do the complete run thru as Scott mentioned
  2. alldodge

    Mercruiser 350 mpi horizon 2007 max rpm 2500 today

    Motor serial number please? and what do you mean by split
  3. alldodge

    Volvo Penta 4.3 GL-EF hard to start

    Move to your own thread Don't know exactly where the diodes are but should be under the fuel pump relay
  4. alldodge

    4.3 cranks idles but dies.

    Before we were looking at it not having enough gas and would die, not it doesn't die but has no power When the throttle cables moves forward does the carb open up? Has the timing been set correctly? If above 2 are yes, then time to get compression test numbers
  5. alldodge

    5.7 EFI stalls when warm and shifting into gear

    You can either get a Merc adapter (91-806901) or can remove item 3 (plug) and attach gauge there https://www.mercruiserparts.com/bam/subassembly/31880/2338/130
  6. alldodge

    sterndrive to gimball

    I would think a new gasket
  7. alldodge

    Anyone please help with my mercruiser 5.7 thunderbolt v igntion engine, hard to start

    With it be hit or miss it;s most likely electrical. Which means your back with the distributor or shift interrupter
  8. alldodge

    Maybe my turn for new boat time

    Don't know who installed OB's my guess was dealer. I plan to call Chap next week to find out. Looking more and more the Lake Cumberland Marine is a never was kind of place
  9. alldodge

    Mercruiser 4.3L lift points

    Yes, so long as they are opposite sides and ends Exp: left front right rear
  10. alldodge

    4.3 cranks idles but dies.

    Unplug switch and put jumper across the terminals. When key is turned ON pump will start to run. If this fixes the issue then its the switch. Don't leave jumper there it's for testing only and not safe to leave i that way
  11. alldodge

    Mercruiser 4.3L lift points

    Yes 4 ft should work but I would suggest 6 ft long
  12. alldodge

    VOLVO PENTA 5.0 GXI Engine suddenly stalled after 10 minutes of running at 3000 rpm

    one of these. Techmate is lowest cost but is not able to record and play back later. Diacom software that goes on your laptop can play back https://www.rinda.com/marine/marinemenu.htm
  13. alldodge

    VOLVO PENTA 5.0 GXI Engine suddenly stalled after 10 minutes of running at 3000 rpm

    Need to get the motor scanned for codes Rinda makes the scanner to be able to scan motor Without a scanner we will be just guessing. Could be a bad connection even something simple like the ignition switch or other bad connection
  14. alldodge

    Mercruiser 4.3L lift points

    If your talking about lift points, sometimes they are removed after install Can use a bolt and put it thru the chain and attach to the head. I like using 2 one inch lifting straps and place them under the exhaust manifolds and attach to hook above carb
  15. alldodge

    Maybe my turn for new boat time

    Sent pics to dealer and their response was they forward them to Chap Good grief
  16. alldodge

    25 EFI fuel pump not work

    Welcome Don't know much about the motor but the fuel pump is turned on by a relay. The ECM does energize the relay by applying a ground to one side of the relay coil. Check the relay and fuses
  17. alldodge

    VOLVO PENTA 5.0 GXI Engine suddenly stalled after 10 minutes of running at 3000 rpm

    What are you using to diagnose? Sounds like something is heating up
Top