Search results

  1. alldodge

    Yamaha won't shut off

    Check your wiring for a broken wire coming from the magneto
  2. alldodge

    Mercruiser 5.0 MPI Fuel Pressure

    Might be there is a restriction causing an issue with the pump. Restrictions can be caused by Antisiphon valve on tank, collapsing fuel line, air entering fuel system, or even the pump. Take a small gas can and length of gas line and go from can to fuel filter. Prime a few times and bleed air...
  3. alldodge

    Mercruiser trim rams

    Is this a MC-1, A1G2,Bravo maybe a year? Yes, you should be able to move them with the lines disconnected. Might have to have a look inside
  4. alldodge

    Can I switch out Mercury 9.9 kill switch?

    The man overboard switch is best if your going to we're the lanyard. If you just want to get a push button switch to kill the motor then find a normally open (NO) switch Being a 2 stroke the switch opens when pressed removing the ground. Could find one at local auto parts or online
  5. alldodge

    Zinc bolt replacement on 2004 formula 41PC transom

    Pic doesn't show up, but a diver that does this kind of work for a living should have seen this before. Ask around other dive shops and see what they say.
  6. alldodge

    350 mag MPI will not turn up past 3500rpm

    Might need adjusting Or just leave it disconnected
  7. alldodge

    Volvo Penta Drive Belt - Lots of dust and quickly wearing??

    If you know the circumference can get/order one shorter. Auto parts house can order or use the Gates book to find
  8. alldodge

    Can I switch out Mercury 9.9 kill switch?

    Yes, just need it connected the same way Does it use a normally open or normally closed contact to run. 2 stroke or 4 stroke
  9. alldodge

    Mercruiser 5.0 MPI Fuel Pressure

    Your correct 43 psi is where it should be at 1800 RPM. Running at 30-35 is to low. Most likely problem is the regulator item 13 https://www.mercruiserparts.com/bam/subassembly/31748/8093/60 Does your motor have a boost pump above the fuel filter canister? First connect a remote tank (small...
  10. alldodge

    4.3 mercruiser overrev alarm

    You got water in there for sure, the filter tried its best to keep it out of the motor. Just more then it could take. Maybe after a bit of running drain the new filter to see if there is any more found
  11. alldodge

    Volvo Penta 5.7 no spark

    Sorry about that, I answered a question on the Formula Forum and that was copied prior. Have no clue why sometimes my browser won't copy another link until I close and reopen https://www.offshoreonly.com/classifieds/rinda-techmate-plus-scan-tools-o82907.html
  12. alldodge

    Volvo Penta 5.7 no spark

    Have to apologies in advance. I noticed his add showed it came with 94029 and 94032 which are the adapters I need for my newly bought motors. So I bought one and he just sold the other. Hope you got the first one if you wanted it
  13. alldodge

    Parts availiability ??

    I looked at NGK and they show the plug as discontinued Looked it up on crossreference and shows NGK 5626 Comparing the 2 on NGK site look the same to me, same heat rage and everything
  14. alldodge

    Volvo Penta 5.7 no spark

    Found this on OSO, has 2 Techmates with 94029 https://www.mercruiserparts.com/496-mag-base-model-0m025000-thru-0m6
  15. alldodge

    Volvo Penta 5.7 no spark

    There is probably nothing wrong with the fuel system, but we don't know for sure. The fuel pump turns ON for couple seconds prior to cranking. The initial ON should still build to operating pressure. The low side pump will bleed off kind of fast but the high side should not Diacom cannot...
  16. alldodge

    Volvo Penta 5.7 no spark

    That's called a Schrader valve There is one on the pump which is the low side and another on the fuel rail where the injectors are attached. If you had a fuel pressure tester (can be found at local auto parts stores) you could test the pressure Low side 4 to 12 psi ( 27 to 82 Kpa ) High side...
  17. alldodge

    Volvo Penta 5.7 no spark

    Low side on pump should be 8 or so psi so it should spray out High side on the fuel rail should be 50 to 60 psi so it should really spray out
  18. alldodge

    350 mag MPI will not turn up past 3500rpm

    Do you have a in gear switch on the shift plate? If so, unplug and try it
  19. alldodge

    350 mag MPI will not turn up past 3500rpm

    Sorry about that my bad will change my post above. Got mixed up and forgot where I was
  20. alldodge

    Volvo Penta sea water pump

    It probably uses the Johnson F6B-9 pump but @Scott Danforth or @kenny nunez should know for sure https://www.amazon.com/RELIABLE-PARTS-SYSTEMS-Impeller-Engines/dp/B01BO3AY9I/ref=psdc_15725491_t1_B00K8EP10C
Top