Search results

  1. Scott Danforth

    Mercury wiring

    Factory service manual has schematics
  2. Scott Danforth

    Mercruiser Oil Pan Replacement and Protection

    Paint.....then annual application of boeshield or fluid film Pan is cheaper direct from GM
  3. Scott Danforth

    Quicksilver 3000 replacement options

    Read the rules on posting in old threads
  4. Scott Danforth

    How to plan a route? is there an app like trip advisor?

    Get paper charts, map your route.
  5. Scott Danforth

    Trouble coming on plane

    No, they don't do anything but put holes in your outdrive and make your wallet lighter. A 5.7 is a bit light of a motor for a 28 foot boat Is this a new to you boat? Is the problem new? What is your compression numbers? What is your fuel pressure? Have you had the boat weighed? You mentioned...
  6. Scott Danforth

    Ski bar recommendations

    Just get a bridle. The center float keeps it out of the motor.
  7. Scott Danforth

    Quit My Job . . .

    You know where to get the logo embroidered.....
  8. Scott Danforth

    Mercruiser 1.6L Vazer

    Most of the vazers were recalled under warranty because they all failed There are no parts, there is no service. If the heat exchanger is leaking, take it to your local industrial radiator shop. They can fab up a conventional heat exchanger to replace the rubber tube sheet one. If I recall...
  9. Scott Danforth

    Dragfluid's newbie thread

    Welcome aboard
  10. Scott Danforth

    What is Normal RPMs running In Neutral and out of water with ears?

    I don't run a choke, my motor runs about 550 RPM cold (after running about 1000 RPM for a minute with some throttle), Bout 650 RPM warm. That is on land or in the water
  11. Scott Danforth

    merc 3.0 carb low speed idle setup.

    Start about 3/4 out from seated on the idle mix. The rebuild kit will have instructions
  12. Scott Danforth

    97 SeaRay 175 project boat hull weeping question

    It will cure hard in high heat...... If the temp is high, it will even cure in the bucket
  13. Scott Danforth

    VP 4.3GS Carb Tuning Vacuum Port?

    That may push your needles open
  14. Scott Danforth

    97 SeaRay 175 project boat hull weeping question

    It remains tacky for the next layer, or until you apply gel (and then spray a coating of PVA to final cure)
  15. Scott Danforth

    Prop size 1989, Mark cruiser, 3.7,18.9

    And what RPM are you spinning at WOT
  16. Scott Danforth

    Fuel Tank Access

    Every boat was hand built, so each will be different. Use a stud finder
  17. Scott Danforth

    VP 4.3GS Carb Tuning Vacuum Port?

    If the float is too high, fuel gets pushed thru the boosters As Lou asked, are the floats cutting off flow?
  18. Scott Danforth

    Need Cover caps on support rods

    Google Bimini top fittings.... You will find what you need
  19. Scott Danforth

    1999 SEI186 Fuel Tank and Fuel Sender

    Guys, this is an old thread, read the rules on posting in any thread older than 90 days unless it's your own thread
  20. Scott Danforth

    Antiseize on sparkplug threads

    Snorted beer out the nose
View older results
Top