Search results

  1. R

    1977 25HP Evinrude cutting out.

    Check the reed valves.
  2. R

    1958 Evinrude 7-1/2 Fleetwin carburetor overhaul

    There is no oil seal , rubber or carbon.----Just a slinger.----Do not worry about the notch.
  3. R

    Mercury 40 hp two stroke

    Neutral switch in the control box.
  4. R

    Is anyone else seeing odd behavior of the site?

    Behaves one minute and not the next.----Typical computer and IT stuff.----Always making changes.
  5. R

    Starboard cylinders overheating, but no thermostat installed

    replace the diverters.
  6. R

    1973 Mercury 850 Won’t Idle

    Make sure that the reed block are located on the dowels.
  7. R

    Starboard cylinders overheating, but no thermostat installed

    Test compression with another gauge.----At 90 PSI they appear to be low.
  8. R

    1984 OMC 200HP compression

    edited
  9. R

    Help! 1968 33 HP Evinrude

    The only thing that could go wrong is the diaphragm in those pumps.----Easy / cheap ( $10 or so ) to replace.----Run the carburetors dry for extended storage.----An empty carburetor stays clean and will require a minimum of maintenance.----New float valve once in a while.----Used parts are not...
  10. R

    1992 70hp Johnson - electrical issue with Trim and Start and gear shaft position fail

    Used parts are easy to find.----But it depends on your location.
  11. R

    '88 Force 15 "Where's the thermostat?"

    Is your motor an 88 model ?-----Model # is ??
  12. R

    electrical and tilt lock: 1968 mercury 200

    The motor does not need 12 volts to run.----Just needs 12 volts for the starter to crank it over.-----Most outboard have a stop switch / button to short the ignition to ground to stop them.
  13. R

    puzzled 88 85 hp has strong spark on number 2 cylinder and super weak spark on 1,3

    I would say you do not have spark on #1 and #3 cylinder.----Should be easy to figure out I think.
  14. R

    1992 70hp Johnson - electrical issue with Trim and Start and gear shaft position fail

    There was a service bulletin in 1994 to move the tell tale fitting from the side of the block to the top.---Factory kit 0432955 has all the bits and information to modify / improve cooling on this motor.
  15. R

    Lapping flywheel

    Agreed----You are over thinking.-----The whole concept of taper ( locking ) fits is much mis understood !!----Just like many other " outboard motor " simple concepts.
  16. R

    electrical and tilt lock: 1968 mercury 200

    The 68 model likely had no room under the flywheel for a charging coil.----
  17. R

    Lapping flywheel

    ???----You might need a dial indicator to see how much it moves down when tightening the nut !
  18. R

    Year of this engine, is it a Lark 10??

    And if the lark does not have the generator you will need to find one and install , commission it on this Lark.-----The electromagnet in the gearcase draw constant power when in gear.
  19. R

    Year of this engine, is it a Lark 10??

    Plain as can be !----The belt driven generator is mounted on the port side.-----Looks much like the starter on the starboard side.---Post a picture of this lark showing the carburetor , starter and generator.
  20. R

    Year of this engine, is it a Lark 10??

    So did the young lady come with the motor to give the operator instructions ? ?
Top