Search results

  1. alldodge

    Mercury 6.2L Loss of Planning Power/ Top End

    Don't worry about the fuel supply disconnect the coil
  2. alldodge

    2001 Mercruiser 5.7 EFI No WOT Under Load

    The folder is empty Do a compression test
  3. alldodge

    Steering actuator vibration

    My point is doesn't matter if its the motor making it shake or the steering, it should not shake that much
  4. alldodge

    Mercrusier 350 MAG MPI - RPM issue under a load

    Those are iridium plugs and don't try to adjust, the thin coating will crack You have the correct plugs for the motor Advance is good You have done everything correct. It should be producing enough power if it was rebuilt correctly. Don't think I asked this before, but look for the casting...
  5. alldodge

    Solar Power Installation . . .

    I've used the stuff a couple times and it does help, mostly trying to pull house wire thru conduit https://www.lowes.com/pd/IDEAL-32-oz-Clear-Wire-Pulling-Lubricant/1017915
  6. alldodge

    Mercruiser ECM replacement?

    Replaced the wires and plugs and it runs better, great As mentioned in post 21, Ebay injectors in most cases are junk. Ebay sells old junk injectors as new/rebuilt. Your still flooding and you need new injectors
  7. alldodge

    Mercruiser Vapor Lock Kit Install

    Yes your motor has a VST (vapor separation tank) Your mechanical belt driven fuel pump is keeping the tank filled but the fuel rail is is heating up and vapor is building. You could bleed the fuel rail each time it does it to get going, but that puts a gas soaked rag in the boat Your motor...
  8. alldodge

    Lower compression in one cylinder boat won’t start… ideas before I tear down 😒

    That's a Merc carb
  9. alldodge

    starter

    What happened a month ago before this started ,everything was no issue or is this a new to you boat.?
  10. alldodge

    starter

    Need more info You hear a noise but what else is going on? Does it start to crank over or does nothing move?
  11. alldodge

    Mercruiser Vapor Lock Kit Install

    No, that's not what it does or how to connect My original motor was a 502 with VST and did VL. The Merc is a boost pump which is installed after the fuel filter and before the Gen 2 high pressure pump. There is no fix for the VST, and as to what is actually happening a boost pump before the...
  12. alldodge

    Mercruiser 3.0l TKS stalling

    If it was my boat I would pull the carb
  13. alldodge

    A1G1 Top gears

    My buddy has a 18 foot Checkmate, 383, drive extension and A1G1. He is easy on the stick and its a very old boat and drive is still original. I think what has saved it is its a really light boat
  14. alldodge

    Mercruiser 6.2l 300 (2018 model) Gimbal bearing grease how to?

    Vibration throttling up is either the prop or the drive in most cases. If prop is in good condition, look at the gimbal bearing and the U joints
  15. alldodge

    A1G1 Top gears

    Have not heard of Cryo stuff on gears, but normally the gears would last more then one life time if maintenance is done. A Alpha drive should not have massive power behind it. Look forward to the comments of better gears but maybe just a new SEI upper will outlast most of us
  16. alldodge

    Trim pump

    BTW when you talk cycling, you are going full up and full down each cycle?
  17. alldodge

    Mercrusier 350 MAG MPI - RPM issue under a load

    New motor and 150 psi all cylinders New ECM from Merc Firing order is correct and there is no misfiring, just low power Timing is dead on correct using the timing tool per bulletin For me, not the sharpest tool Only thing left is there might not be enough advance in timing, or not enough fuel...
  18. alldodge

    Trim pump

    Did ya by chance look inside the tank before installing? Look for some note left inside side saying something stupid like add oil before using. :unsure: Just another thought if it might get caught against the intake to cause the cavitation
  19. alldodge

    Volvo DPS-B Won't Stay Trimmed Up

    More then likely provided the cylinder is not scored inside. Cannot vouch for after market kits because I have never rebuilt a VP cylinder, only Merc and a bunch of other hydraulic cylinders on farm and heavy equipment
  20. alldodge

    Kohler 5E Generator shutting off after 3-5 minutes of operation

    Water comes from the thru hull, then thru sea strainer to Gen. Water then goes thru Gen heat exchanger and dischargers over the side
Top