Search results

  1. R

    3.5 chrysler outboard

    That is the simple air cooled little motor.----Stayed the same for many years.
  2. R

    Johnson 90hp alarm buzzer

    Are you saying there was no buzzer in the control box ?----Tested to see if there was an alarm?-----Picture of your control box ?
  3. R

    3.5 chrysler outboard

    For a 1984 it is sierra-18-7037 carburetor kit and 10 listed in stock.
  4. R

    No pee Johnson outboard

    Starter fluid does not bother a cold motor for one starting attempt !!!
  5. R

    Water issues

    Time to consult the local Yamaha shop.----They may have seen the issue before.
  6. R

    3.5 chrysler outboard

    It is clearly listed as available.-----A good Mercury dealer can get it for you !!
  7. R

    03 Johnson 50 four stroke outboard blowing main fuse

    Make sure battery leads are on the correct terminals for your Suzuki motor.
  8. R

    1990 Force 50HP

    Make sure both cylinders are firing.
  9. R

    3.5 chrysler outboard

    Mercury dealer can get you this kit.-----Or sierra aftermarket.-----Not hard to find I think.
  10. R

    3.5 chrysler outboard

    Typical diagnosis.-----Any other trouble shooting done ?
  11. R

    High RPM surge driving me nuts!!!

    I do not believe larger OMC motors were ever meant to run at 100:1 mix.----It was a brief exercise by the board room in the mid 1980's to run the 6 and 8 HP / and 9.9 to 30 HP on 100:1 mix
  12. R

    Flywheel occasionally locks up

    Bad bearing somewhere I would say.----This is sounding expensive.
  13. R

    35hp Johnson

    Is the J35ETCS a 1980 model ?----Pictures help.----Are you sure it is not 5" difference.
  14. R

    Stuck in drive

    ----What happens when you turn throttle handle to idle position ?
  15. R

    1988 50hp Evinrude tilt/trim sensor

    Yes , I know what the cylinder looks like.-----Inspect , test ohms as motor goes up.-----Inspect parts and repair as needed.
  16. R

    2005 90 johnson fuel pouring

    I thought to reply just in time before it went ---No reply here !!!
  17. R

    Need help !! Reverse gear won’t come out of the prop shaft

    It should fall out.
  18. R

    Need help !! Reverse gear won’t come out of the prop shaft

    Need model # here.---That gear should fall out onto your work bench when propshaft is given a bump on the bench.------Sounds like there is more wrong like bad gears !!---Busted clutch dog.--Any metal chips in the gear oil ?----Any water ?----And yes I looked at a reverse gear 15 seconds ago to...
  19. R

    2005 90 johnson fuel pouring

    How did this motor run for you last season ?-----Fuel leaking out means that float and float valve need attention.----Needle could be stuck from carburetor sitting with fuel in it.
  20. R

    Trust the dealer?

    Friends of mine used to have a 35 HP 1959 Johnson in the family.------Then graduated as funds allowed.----New 1966 model 100 HP Johnson on a bigger 17' boat.-----The father said ---" You know this 100 HP does not use that much more in the way of fuel "-----Much of that is due to the fact that...
Top