Search results

  1. Scott Danforth

    Black Box (literally) Under Dash--what is it?

    most likely it is the fuse holder for the radio
  2. Scott Danforth

    How do these manifolds, risers, elbows look? 1998 5.0Gi's

    FYI, VP uses Barr and Osco for factory castings.
  3. Scott Danforth

    5.0 mpi to 383 conversion thoughts?

    OK, I will do the work for you. here are the two options that I know still reflash https://www.hardin-marine.com/c-2250-ecu-upgrades-and-tuning.aspx https://whipplesuperchargers.com/index.php?dispatch=categories.view&category_id=172 Simons may or may not reflash anymore. you will have to...
  4. Scott Danforth

    Gent's, I think I screwed up

    OK, Lutefisk then..... :p
  5. Scott Danforth

    Old Boater Collections

    speaking of filters..... anyone need filters and parts for a 1998 VW Jetta GLX or a 2003 Audi A4 Avant with a 3.0?
  6. Scott Danforth

    1995 Stingray 4.3L Mercruiser No Start

    first, welcome aboard next, clean all your connections from the battery to the helm neutral safety switch is in the binnacle control. hope you stored the boat without fuel. if not you will be cleaning the fuel system.
  7. Scott Danforth

    Gent's, I think I screwed up

    your wife is also from Wisconsin..... she would probably hit you with the fry pan.
  8. Scott Danforth

    1991 US Marine L-drive Taking on Water

    most of the parts for the L-drive are NLA or soon to be NLA As racerone stated. RUN besides the motor issues, its a 1991 bayliner. RUN!
  9. Scott Danforth

    How do these manifolds, risers, elbows look? 1998 5.0Gi's

    shoot him get factory parts or Barr or Osco. not Sierra, Not HGE
  10. Scott Danforth

    5.0 mpi to 383 conversion thoughts?

    there are only two places to get your ECU reflashed. been covered on the site. need to know which ECU you have. do a search.
  11. Scott Danforth

    Easiest way to weigh a boat

    no, its been addressed. if the trailer is non-registered, that is a red flag.
  12. Scott Danforth

    Gent's, I think I screwed up

    the OP's comment to his wife was removed either by the OP or by a Mod. either way, if I stated that comment to my wife...... I would wake up 3 days later in a hospital. She doesnt take carp from me or anyone. However, at times I curse enough to make a longshoreman blush.
  13. Scott Danforth

    Mercruiser 4.3mpi Tach

    regardless of induction. the coil still has a ground wire. look at the coil connections.
  14. Scott Danforth

    Volvo Penta SX - water leak help

    need to pull the motor to look at the y-pipe could also be steering pivot, or it could be bad transom
  15. Scott Danforth

    5.0 mpi to 383 conversion thoughts?

    you will need to get the ECM reprogrammed for the stroker motors. since all the Small Block chevy motors are dimensionally identical from the 265 to the 400 cubic inch. yes, dropping in the 377 or 383 or even a 396 standard deck SBC is possible. if you can have the exhaust manifolds spread...
  16. Scott Danforth

    How do these manifolds, risers, elbows look? 1998 5.0Gi's

    the cooling passages are clogged with rust. time to buy new ones.
  17. Scott Danforth

    Easiest way to weigh a boat

    if the boat is neglected and sitting on an unregistered trailer. assume its waterlogged and move on to the next boat in your search.
  18. Scott Danforth

    Gent's, I think I screwed up

    Nah.....that comment is "see jewelry department"
  19. Scott Danforth

    Dented pontoon log with tear

    You may or may not have an option depending on your insurance company and your policy
  20. Scott Danforth

    Dented pontoon log with tear

    Anything man made can be remade. However the cost to repair will be more than it's value
Top