Search results

  1. alldodge

    Bennett Trim Repair And Auto Pro Install

    Today I tried to trim and the tab turns ON and doesn't turn OFF. So stop the motor, turn the battery switch OFF and it stops. Turn it back ON and its not running, so I'm leaving it alone Bennett never replied, so I called and got the same guy. Anyway, their sending me a entire new package...
  2. alldodge

    5.7L Black Scorpion running rough after warmed up

    Could also put a fuel pressure gauge on the fuel rail and see if its holding at 43 psi
  3. alldodge

    5.7L Black Scorpion running rough after warmed up

    Thinking its starving for gas. Being able to let it idle for a short time and run good again for a short, I would start with the gas tank vent. Could be the tank is drawing a vacuum because the vent is clogged, or partly clogged. When it does this remove the gas cap and listen for air being...
  4. alldodge

    2004 mercruiser 4.3 thunderbolt ignition

    This is for TBV but its the same for TB4
  5. alldodge

    Still running hot, please help .

    Tan wire temp gauge Tan/Blue alarm switch
  6. alldodge

    Still running hot, please help .

    The one with only one wire attached , Tan wire
  7. alldodge

    Still running hot, please help .

    Good, your overheat issue is fixed, now its a gauge/sender issue Check your sender with a ohm meter and pan of water
  8. alldodge

    PCM no spark! HELP

    I got nothing Guessing from first post: The ECM was fired somehow. You got another ECM but did not find out what fried the first one prior, so it fried the second I hope that is not the issue, but just guessing
  9. alldodge

    PCM no spark! HELP

    Dealer isn't a PCM dealer. I would normally say look to Rinda, but being this is a PCM 555 (and not a Merc PCM 555) it doesn't look like Rinda had anything to read it. Sorry to say, but I'm out of my league to help.
  10. alldodge

    PCM no spark! HELP

    Thanks 555 ECM
  11. alldodge

    350 mag 5.7l skipping

    Serial number?
  12. alldodge

    PCM no spark! HELP

    Which ECM/PCM do you have? I'm looking and think I'm seeing it as a MEFI-4 Does it look like the one in the pic?
  13. alldodge

    1987 Starcraft 191 select trim switch

    Suggest spending some time in the link in post 7 Your posted in The Merc section, so the link should have 1986 to 1993 controls. So unless its not a Merc control it should be there
  14. alldodge

    2000 merc 5.0l alpha one gen two

    The lube bottle, is open (has lube) or closed (has no lube) and it just grounds one side. Don't throw parts at it, get it scanned, or use the paper clip and LED to figure it out
  15. alldodge

    5.0Fi PHUECE boat dies under load

    Needs to be in gear so the load increases
  16. alldodge

    1987 Starcraft 191 select trim switch

    I think its this one. At any rate the switches should be the same but would not swear to it https://www.mercruiserparts.com/bam/subassembly/32078/1989/100
  17. alldodge

    Delco EST High Idle

    But still need to remove the throttle cable from the carb. The cable might need adjusting to let the carb idle slower
  18. alldodge

    Bravo 1 whining noise at 3000 rpm

    If anything else, remove the prop and behind the prop will be the drain fitting. Loosen the plug with a large screw driver real slow. All you want to do right now is remove it enough to let a little lube out. If its nice greenish lube then the lube and no water, or other color your probably...
  19. alldodge

    Bravo 1 whining noise at 3000 rpm

    Sounds are hard to determine in writing. That said, the Bravo should be fairly quite. Being a new to you boat you should have all the regular maintenance done Pull drive and change gear lube Change impeller and inspect raw water pump housing Check engine alignment Check gimbal bearing Replace...
  20. alldodge

    Volvo Penta 4.3 GL ~2000 model year. no fuel - where are the diodes and what size are they

    Lots of corrosion issues with boats. Could get a new relay plug and relay (same as marine) from the auto parts place. Cut the old out and replace Or could replace with Merc style using a oil pressure switch Have found some of the VP don't have the diode on the green wire. Only if the...
Top