Search results

  1. R

    1980’s Evinrude - Temp Warning System?

    Model # of your motor ?
  2. R

    1980’s Evinrude - Temp Warning System?

    If you are handy you could add the warning horn to your motor.
  3. R

    1979 Johnson 100hp V4

    Do you know what was done for the " rebuild "-----Was it new rings on old pistons.----Bored out with new O/S pistons ?------I would be removing the 4 bypass covers to inspect pistons and rings.
  4. R

    1980’s Evinrude - Temp Warning System?

    Model # of your motor?---Why did you not install the correct impeller.-----A new impeller every 5 years is the way to go.----Some electric start models did have a warning horn.
  5. R

    Choosing an Inboard for homebuilt 20' Glen-L Runabout Monaco

    Find a ski boat with a V-8 Mercruiser ( inboard ) or similar for all the parts you would need
  6. R

    $50 150hp Gambling project (pics)

    If it is the part added for the dual cable steering at the motor , how did you determine that would be expensive ??
  7. R

    What are these holes for in this carbeurator drain manifold

    I believe that is correct.---One hose from earlier crankcase ventilation was fitted there.
  8. R

    Choosing an Inboard for homebuilt 20' Glen-L Runabout Monaco

    Find a donor boat with V-8 Mercruiser.-------That would have everything needed for the installation.----Often available for $1000 or less.
  9. R

    2012 15 HP Honda Outboard cutting out when giving it throttle.

    Compression seems low for a 4 stroke.-----Open low speed mixture screw 1/8 turns at a time and see if bogging goes away.
  10. R

    Chrysler Fuel Pump Numbers?

    Landeverde----Perhaps test run with another hose and tank.----Fuel pumps a driven by crankcase PRESSURE pulses.-----So see if there is an issue there.
  11. R

    Looking for help !

    There is no way that I would spend money for a new fuel pump.----They are easy to inspect and repair.----Have you checked water pump ?-----Motor going into the ---S.L.O.W. -----mode due to over heating ?
  12. R

    $50 150hp Gambling project (pics)

    I doubt the boat was parked because a broken steering system.
  13. R

    Olympics

    I was awarded a trophy years ago in hockey.----Most sportsman like player and I played defense.-----.Today I say if I was the referee in some NHL games there would be no one left to play the game after 10 minutes.-----I often said it too.-----Players get a 2 minute penalty doing things on the...
  14. R

    $50 150hp Gambling project (pics)

    Remove bypass covers and inspect pistons and rings.
  15. R

    Piston fit

    So what do your pistons measure 1/2" from bottom of skirt?-----And what do your bores measure just above the ports ?----Post some accurate measurements.
  16. R

    2006 50hp honda serial: BAZS 3600812

    Cable terminal.------About $10 at your Honda dealer.
  17. R

    new to me 1970 Johnson 25hp tiller short shaft. locked up

    Yes they were a flush screw ---10-24NC
  18. R

    2005 Evinrude ETEC 200 no start question

    Ordered a new flywheel ?-----Did you do injectors one at a time ?-----Put them back in the same hole ?
  19. R

    new to me 1970 Johnson 25hp tiller short shaft. locked up

    Somebody struggled with that oval cover in second picture.----Broke the 10-24NC screws and went to 1/4-20 NC in there.
  20. R

    Rotten Boat Factory

    The cost of labor to fix them is the issue.-----Most were not made with good materials.-----And they were never assembled to be repaired.------The sad part is that many similar boats are still being used.-----Folks have no idea what is in the transom or under the floor.
Top