Can you explain this a bit more?
Can get fuel to the pump from a handheld?
Can from the inline filter to the carb but nothing from either tank?
Some of these boats have 2 filters and one is down low in the bilge forward of the motor. Have you followed the fuel line back to the tank?
No that doesn't do the same, it list the newest post, posted, not newest threads
Also looks like I need to figure where the quote button is, if there is one. Thried reply and that didn't work
The New Topic button is not there like the old.
It was my go-to button to see any new threads started. Could scan thru them to see if someone posted and had no response.
If the impeller is not pumping sufficient water then exhaust gases can back up and melt the tube
The missing seal can causes issues, but to find out if the drive is sealed, pressurize the drive prior to filling with gear lube. Pressure should be no mor then 10 psi and do rotate the prop and...
Check the gray wire with coil disconnected from harness, and disconnect tachometer, then to determine gray wire is not grounded. Disconnect the shift interrupter
If you get power to the coil when key is turned ON, and connections to other wires are good, then I would say it most likely is the...
Bought 4 - 2in wide, 4ft long lifting slings from US Cargo
The slot on the bracket is so tight I had to cut away the vinyl to get sling eye thru. Debated on to push eye through the slot and use a bolt of some sort to keep eye being pulled back thru, or loop the sling back thru the eye. The...
Did this issue just start or was there anything which shuld some kind of signs prior?
Being a 97LX and no serial number it should have EST distributor. Check the distributor
What is the voltage level of the battery?
Check for 12V at the main power relay when key is turned ON. Should have full time power on the Red/Purple and Pink/Green. When key is ON should see power on pin 87 Red/Black
It's strong but leaning toward quality 2 inch strap and sliders. This way I don't need to sew it together (have sail palm). Will look for ones with a load rating specified
This would allow me to adjust and be good
Have a PWC lifting sling I bought several years ago. Its a Erickson (Made in China) rated at 1000 lbs and says right on it "use at your own risk". Did not notice the label when I bought it, but did understand the rating.
Have lifted using it numerous times. Used it today, lift a bit and go back...
