Search results

  1. alldodge

    Mercruiser Bravo 1 Transom Plate (back) is Slightly Curved???

    I don't see it as an issue, there not enough there that would cause an issue. My guess is this was one which was removed and now reinstalled, and meant that your transom (old or new) had a variation, and over time the plate stayed that way. Appears to be within spec for a new transom
  2. alldodge

    mercruiser 4.3L bellows relacement

    Reach in and see if you can feel the back edge of the race against the assembly. There is not much difference there. Did you clean off the area before install?
  3. alldodge

    5.7 Mercruiser Thunderbolt surge at high rpm

    Rubber fuel line, Tee fitting and barbed fittings for connection to the carb and pump Or get this and attacch at carb end 91-18078 Then need a vacuum fuel pump tester, could probably get a loaner from auto store...
  4. alldodge

    mercruiser 4.3L bellows relacement

    Merc puller install kit is 91-31229A7 but most don't need all of it. If you get the Mandrel 91-30366 (item d) then make you own drive piece to install.
  5. alldodge

    Fuel pressure adaptor

    Yep, its Actron 0180-000-1320 , just look for GM TBI fuel pressure adapter
  6. alldodge

    5.0l cobra efi no power to fuel pump

    Have limited amount of info on the TBI, but start/run should be similar. The relay would be my first thought.
  7. alldodge

    Blue Seas Add-A-Battery Kit - 120A 7650 - need a wiring diagram I/O and kicker

    This should work It can be done with 3 bat switches but 2 will work. The House bat switch should only be used to combine bats if start bat is to low to start main motor
  8. alldodge

    Ignition Switch Confusion

    This is the reason I mentioned an inline fuse or fuse panel. On your style boat, the fuse is normally not on the helm but under it using an inline fuse
  9. alldodge

    5.0 mpi overheat at higher rpm.

    Pic to help
  10. alldodge

    5.0 mpi overheat at higher rpm.

    If you see bubbles then your sucking air. If you notice your cooling during normal operation is, thru the engine water pump, thru block, out thru thermostat housing, to exhaust. When thermostat is closed there would be a small amount of water coming from the block and out the exhaust. There...
  11. alldodge

    5.0 mpi overheat at higher rpm.

    Ok you have the single point drain system with the Alpha drive. https://www.mercruiserparts.com/bam/subassembly/31849/8093/200 Place a clear hose between item g (cool fuel) and f (water dist housing). Then see will in the water if there are any bubbles. Also use the pic to make sure the...
  12. alldodge

    Bravo I, II & III interchangeability question

    From your previous post your needing the bell housing (part of the transom assembly), and yes most any can be used with one caveat. On top of the face or the housing look for slots on the top. The slots are there so the U bolts do not come in contact when fully raised. You can use the one...
  13. alldodge

    trim/tilt line leak repair help

    Appears so, you know more then I. This kind of lines the O ring does the sealing but nut has to be tight. Th
  14. alldodge

    2001 sea Doo GTX RFI

    From looking at the manual it shows a Black/Pink and Purple/Pink wires feeding the pump. Guessing from the colors I would say Purple/Pink is hot and the other is grounded by the computer to turn it on
  15. alldodge

    Click but no start

    Howdy, we need to know what motor your working on (merc, VP, 3.0, 5.7 etc)? Once we know we will have a better idea of how to fix it and maybe GA_Boater will move it to that section Is the battery fully charged and measuring between 12.5 to 12.7 volts? Are the battery cables clean at both...
  16. alldodge

    water not draining in engine compartment

    I doubt if there is a drain. Most cases it gets drained when the boat leans enough to dump it in the bilge. Here's mine (not a searay) on the starboard side, and it use to be flat until I did transom repair
  17. alldodge

    Mercruiser 555 - ECM no power?

    Sure looks like the same ground, note splice 104 on letter m which is everywhere CAN, sensor and ignition
  18. alldodge

    Mercruiser 555 - ECM no power?

    Yes your thinking correctly, in typing I switched the tags, its correct in post 6
  19. alldodge

    454 MAG. BRAVO MPI (GEN VI) GM 454 V-8 1997 Crank No Spark

    If your meter is good, the 12.3V is barely on the good side, and a bit low. Should run if it ever starts
  20. alldodge

    454 MAG. BRAVO MPI (GEN VI) GM 454 V-8 1997 Crank No Spark

    Removing the red kills all power to the coil so there will be no spark Code 33 is MAP voltage high, so disconnect MAP connector and measure voltage on Lt Green and Gray. The MAP will not keep the motor from firing Check out your distributor
Top