Search results

  1. alldodge

    Chrylser 105 Conqurer

    Pulled the top off today Removing everything off the dash. Inside the hull
  2. alldodge

    8m0095310 trim sender problem

    My HP transom assy came your the 3 wire digital sender you mentioned. I had to install the digital to analog converter because my gauge is analog. From what I have found, and there is not much, it should be plug and play for your smartcraft gauges. The one sender replaces the two and uses a...
  3. alldodge

    Bravo 3, 3x3, 4x3, 4x4

    Searching the net I find all kinds of right ups. bblades seems to have the skinny, but I would still like to figure out what's best for my issue. Have 4 sets of 3x3 B3 prps, 22, 22 cupped, 24 and 26 pitch Current, 11K single engine cruiser (Formula 27PC). A 502 producing 530 or so HP and 600 ft...
  4. alldodge

    Bravo III outdrive pickup not picking up water.

    Exhaust flappers are a good thing and to protect your engine they should be replaced. As for fixing the hose issue, if you are unable to get the water to flow freely then the engine will most likely have to come out to replace the hose. If you can get at the fitting it can be done without...
  5. alldodge

    Chrylser 105 Conqurer

    Started the rebuild on the Chrysler. Removed the outboard Removed the rub rail and rivets Also have Tigger to keep me company Need to pick up a tongue jack. If all goes well maybe I'll get the top off tomorrow
  6. alldodge

    Dual exhaust

    You need marine type exhaust system because they need to be cooled by water. You can use your manifolds and risers, then connect exhaust hose straight back to exhaust tips in the hull. Can replace them with ones from Eddie Marine like these...
  7. alldodge

    volvo penta aq170b no spark with new coil ?

    Below is the AQ140 wiring diagram Which is a basic point type distributor ignition setup. Check for 12V at the coil when the engine is cranking. Here is the typical point system which is easier to see Key is turned to start and 12V goes direct to the coil, when released it goes thru a...
  8. alldodge

    Mercruiser 4.3 maxes out at 2200 RPMs at WOT - Please Help.

    Since your on the boat, look on the side of the engine block behind the starter for something that looks like the pic below. If not found look on the other side just to make sure one is not installed
  9. alldodge

    Volvo Penta AQ145A Project

    :welcome: to iboats I'll start with your last question; below is how a distributor with points should be wired. The coil gets a full 12V while engine is cranking, but once started the power goes through a resistor to the coil. Note: this is for a car not a boat (vacuum advance not present on...
  10. alldodge

    Marine switch technical issue.

    :welcome: to iboats Aaron Some how you have one circuit back feeding another. To keep it simple the best way to wire things up is using buss bars feed by a large wire about 10 gage. Pos and Neg then feeds your switch panels. If your switch panel has lighted switches then all switches do need...
  11. alldodge

    Mercruiser Fuel Pump Old vs New Design

    These links should work Old Design http://www.mercruiserparts.com/Show_Pictures3.asp?dnbr=41261&ivar=images/CRUISER/41261/23.png&inbr=963&bnbr=110&bdesc=FUEL+PUMP+AND+CARBURETOR+%28OLD+DESIGN%29 New design...
  12. alldodge

    Ignition Switch

    :welcome: to iboats The yel/Red is for your starter solenoid, if your blue wire connects to the solenoid on your engine it should work. Make sure your blue is not purple
  13. alldodge

    Mag 350 MPI alarm problems

    Codes don't go away automatically, need to have them cleared. You either need a scanner or been told you can clear it with the following method (haven't tried it yet). Turn ignition on (don't start), put a paper clip between points A and B on the DLC, move throttle handle to full forward...
  14. alldodge

    Borg Warner Velvet Drive - Direct

    :welcome: to iboats It's a 5/16 steel ball (item 47) part number 453632. This is a blind hole which does not go thru to the inner cavity. Leak will not happen in this location.
  15. alldodge

    TKS issues with 3.0 Where does the power supply link?

    The oil pressure switch provides a ground to the YKS module. 12V is applied via 1 20amp fuse via the engine circuit breaker.
  16. alldodge

    4.3 Merc Running too cold at speed

    I take it since you have a 160 thermostat then your serial number is above 0L341000 and looks like the one on the right. Did you buy a Merc or off brand thermostat?
  17. alldodge

    Hard starting after running

    The choke plate is the plate that closes down when the engine is cold, it should be full open when warm. In the pic below this is a 4 barrel but the plate in the fore front is the choke. Need to find out if your loosing spark. If you have a timing light bring it with you and connect it on the...
  18. alldodge

    Upgrading 65A Alternator to a 130A

    You could keep it like it is and wait and see if the breaker will blow. If the breaker blows then you need to bypass it and use larger wire. While the ALT can put out more amps, it will only do this if the battery needs it. So if the breaker never blows your OK. If you do need to replace it you...
  19. alldodge

    mercathode and anodes

    The anode is item 32 in the link below if installed, and is installed on the bottom of the transom housing, over item 28 http://www.mercruiserparts.com/Show_Pictures3.asp?dnbr=809759 98&ivar=images/COMMON/5066.png&inbr=2686&bnbr=80&bdesc=GIMBAL+HOUSING The mercathode is item 5 and if installed...
  20. alldodge

    Thru hull conumdrum

    OK then I would suggest the following, Blue is thru hulls with ball valves. Green are the lines to raw water pumps
Top