Search results

  1. R

    79 Johnson 55hp aisle Speed

    You doubt the information.----Should be 140+ on that motor !!
  2. R

    74 9.9 upper motor mount

    You are correct.----They are proud ( $$$$ ) of those mounts.
  3. R

    1993 Johnson 60 hp tj60tletd no spark

    Factory replacement parts or AMAZON specials ?---Follow these simple steps.--Remove 3 sparkplugs.----Hook up leads to a spark test device.----Set gaps at 3/8"------Separate the big red plug on wiring harness.------Pull flywheel over with a rope.----Do you see spark on the test device , yes or no ?
  4. R

    1993 Johnson 60 hp tj60tletd no spark

    Did you torque the flywheel nut to 102.5 FT LBS ?
  5. R

    Mercury kiekhaefer 60 not pumping water

    Is this the 2 cylinder 6 HP model ?----Water must be 6 or 8" above the impeller when running in a test bucket.----Also the plastic washer at the very top of the water tube could be melted.
  6. R

    1976 Merc 65HP - Filter Inlet Cover help needed

    There appear to be some aluminum ones shown on the internet.----So I believe a new one is available somehow.
  7. R

    79 Johnson 55hp aisle Speed

    Fact-----Compression on that motor should be 140 + PSI.-----So you have a bad gauge or a motor with issues.
  8. R

    1990 8 hp Evinrude

    If it has the fine splines at the top it will not be easy to find.----Your location ?
  9. R

    1993 Johnson 60 hp tj60tletd no spark

    Don't throw the old parts out yet.--I think you have a lot of good spare parts now.-------Now start with some trouble shooting.-----Load test the battery.------Take starter apart for inspection and an ohm test on armature.----No money spent on those steps.
  10. R

    Johnson 150 Rebuild/Remanufacture Guidance

    Rings have noting to do with the smoking.----I recommend you take it apart.----Measure and inspect everything.----All new gasket set and crankshaft seals.----Inspect all crankshaft seal rings.------And 6 new 0.020 O/S Wiseco pistons.----Don't forget to make sure lower unit is inspected and...
  11. R

    1957 Eveirude Lark 35hp

    The mix was 24:1 in 57.------It will run on 50:1 but it may not last as many years on the leaner mix.-----Oil / lubrication in 2 strokes is not well understood.
  12. R

    1984 6 cylinders Mercury lower unit assembly

    What happens when you assemble this and turn the shift rod counterclockwise. ?----Requires some effort.------Then you get neutral and reverse.
  13. R

    1976 Merc 65HP - Filter Inlet Cover help needed

    Make the part.------Stainless come to my mind.
  14. R

    1990 Envinrude 9.9 only goes at idle speed wont go wot

    How did it run last year for you ?-----Sounds like it is running on one cylinder.------Check compression .----Check for strong spark on both leads.----Reed valves checked ?
  15. R

    Famous shift shaft

    Sounds like upper and lower shift shaft are not right.---Expensive damage can occur here.-----Hurry to a shop.---They can correct the mistake in just minutes.
  16. R

    1957 Eveirude Lark 35hp

    Look on the ----aomci------website.----There may be an old gray haired expert in your area that can help.----Also a free ----wanted ----section to help searching for parts.
  17. R

    1976 Merc 65HP - Filter Inlet Cover help needed

    Your location ?
  18. R

    Power pack or stator???

    Well----1/4-20 NC are 60 inch lbs.
  19. R

    84 Johnson 9.9

    A 36 year old motor.----Time to install a seal kit.----Make sure you replace the o-ring seal on the shift rod.-----Water leaks appear normal to me.
  20. R

    Fuel pressure for Evinrude V6

    Well 4 psi will do it.----But the factory diaphragm pressure pumps are ultra reliable and safe.------What is your motor doing / not doing and why are you picking on the fuel pump as the issue ??
Top