Search results

  1. S

    jack plate wiring

    I am mounting a jack plate with tilt it has 2 wires, what will i need to wire, is it possible to work without relays? any help, ideas appreciated, thanks
  2. S

    6hp evinrude compression?

    i have a 1973 6hp evinrude question, what should be good compression? thanks guys
  3. S

    1988 70hp yamaha trim motor

    housing looks good on the outside.i have never been able to put one back together once i take it apart
  4. S

    1988 70hp yamaha trim motor

    my trim locks up, just clicks, up or down, when i tap on the motor it works again,. is this something i can repair, or do i need to buy a new motor. this motor has set up for a long time. thanks guys
  5. S

    1975 25hp evinrude little spark

    trying to bring this old motor back to life, it has very little spark, almost none at the plugs. where should i look first? thanks guys
  6. S

    1986 40hp yamaha oil to gas ratio?

    I have removed my oil injection, do I mix 50 to 1 or 100 to 1 thanks for any info
  7. S

    40hp yamaha trim wiring diagram

    40ETLG sorry, thanks
  8. S

    40hp yamaha trim wiring diagram

    Is there anyplace i can find a wiring diagram for tilt and trim? thanks
  9. S

    yamaha 2000 25hp f25eshy no fire

    it is an electric start, battery is new and spinning fast. Battery is not the problem
  10. S

    yamaha 2000 25hp f25eshy no fire

    yes, no fire to spark plugs
  11. S

    johnson motor year model

    you right MQ-12A it is a 25hp, 1966? thanks
  12. S

    yamaha 2000 25hp f25eshy no fire

    i know how a outboard works. my question was trouble shoot a motor with NO fire thanks
  13. S

    johnson motor year model

    i cannot find a year model the model is mc-12a any one? thanks
  14. S

    yamaha 2000 25hp f25eshy no fire

    motor was running fine when i put up for winter. today it will not fire. fuse is good kill switch is connected, i do not no what to check next. any ideas or suggestions greatly appreciated. thanks guys
  15. S

    1990 40hp evinrude

    what would be first suspect?
  16. S

    1990 40hp evinrude

    motor was running fine, shut it off, then will not start, no fire at all
  17. S

    1990 40hp evinrude

    is there a way to check the stator not running? thanks guys
  18. S

    evinrude carbs

    i have taken apart and cleaned. Float and valve are working perfectly. The gas goes directly to the top before the float chamber. I am going to try and seal the vent
  19. S

    evinrude carbs

    the black plastic top has notches 2 on each side. squeez the bulb gas shoots a foot out of the notch directly above the gas inlet nipple
  20. S

    evinrude carbs

    that is what i thought also. The float is working properly, there is a port hole connecting the fuel to the top before it gets to the float
Top