Evinrude or Suzuki

[TnTommy]

I’ve been told by a couple people that my Evinrude is a Suzuki any one know for sure it’s a 2000 50hp 4stroke ? Model E50PL4SS

 

[racerone]

The people were correct !!

 

[TnTommy]

I’ve been told by a couple people that my Evinrude is a Suzuki any one know for sure it’s a 2000 50hp 4stroke ? Model E50PL4SS

I’m also a first time boat owner and the boat runs good no problems all summer, I have put it up for winter changed crankcase and gear oil and fogged the motor , but any other maintenance suggestions I should do to keep it running good this spring? I do plan to change all filters and plugs before I run it in spring.

 

[TnTommy]

The people were correct !!

Are they decent motors? Anything I should look out for?

 

[racerone]

New water pump impeller every 5 years.----And do not slam it into anything ( rocks ) that causes a dynamic halt.---Often results in scrapping the motor.

 

[TnTommy]

New water pump impeller every 5 years.----And do not slam it into anything ( rocks ) that causes a dynamic halt.---Often results in scrapping the motor.

Thanks for info

 

[TnTommy]

New water pump impeller every 5 years.----And do not slam it into anything ( rocks ) that causes a dynamic halt.---Often results in scrapping the motor.

You mean the boat itself or the prop hitting rocks, I understand the prop but if I slam into a bank with the pontoons which I don’t plan to do it could cause dynamic halt? What does this do to motor?

 

[racerone]

If you hit a rock with the prop it may destroy the lower unit.----May cause the wee timing chain ( underneath the block ) to skip timing sprockets.----Damage the valves and cause damage beyond the value of the motor.

 

[TnTommy]

If you hit a rock with the prop it may destroy the lower unit.----May cause the wee timing chain ( underneath the block ) to skip timing sprockets.----Damage the valves and cause damage beyond the value of the motor.

Ok I gotcha, I did run into shallow water this summer and hit bottom but I was raising trim up and put in neutral at the time it hit, ended up taking a dime size chunk out of two of the blades, so that ride back it definitely felt more vibration, but after I put new prop on it ran good.

 

[redneck joe]

Stick with aluminum props, they will take the damage and relieve the stress to the motor more.

 

[TnTommy]

Stick with aluminum props, they will take the damage and relieve the stress to the motor more.

Ok thanks

 

[Chris1956]

You did change the oil filter, when you changed the engine oil, right?

Pump grease into the grease fittings and clean and grease the steering rod, if you have one.

You rinsed the powerhead, right? Spray it with corrosion guard stuff.

 

[racerone]

Does the motor have the correct prop on it for operation on a pontoon boat ?----Diameter and pitch of your prop?

 

[TnTommy]

You did change the oil filter, when you changed the engine oil, right?

Pump grease into the grease fittings and clean and grease the steering rod, if you have one.

You rinsed the powerhead, right? Spray it with corrosion guard stuff.

I did change oil and filter did the grease fittings and steering rod, did not rinse power head or use corrosion guard, how do you rinse power head

 

[TnTommy]

Does the motor have the correct prop on it for operation on a pontoon boat ?----Diameter and pitch of your prop?

It’s a 13X11

 

[racerone]

What maximum RPM do you get on your tachometer?