Search results

  1. alldodge

    Volvo Penta 4.3

    Thanks, EST ignition My wiring diagrams don't show the man overboard kill switch, but also don't think that's the problem The purple comes straight from the key to the coil and Alt. There is a possibility the Red/Yel start circuit could back feed the ignition if the Alt diode was shorted. But...
  2. alldodge

    Volvo Penta 4.3

    GL what? A, B, C etc
  3. alldodge

    Mystery bolt found in bilge

    Welcome Alternator or power steering maybe
  4. alldodge

    Volvo Penta 4.3

    Need more info on the old motor Was it a GL- something? It might be the key switch, see if 12V is at the coil with key ON
  5. alldodge

    I'm doing my Bellows. Mercruiser A1G1. Are the Amazon Bellows Kits any good?

    Amazon is fine so long as it's an actual Merc dealer using Amazon.,, can also be Sierra otherwise it's a crap shoot
  6. alldodge

    Old Bravo3 Reassembly connecting Ujoint Bellows to Helmet

    The second groove
  7. alldodge

    3 or 4 blades Crownline 180BR

    Look on side of drive for a numbers like 2.00, 1.50 etc
  8. alldodge

    2025 Carolina 178JLS Leans to Port Side

    Welcome It's not because of saltwater or any kind of water, it's the design of the hull The prop is rotating clockwise and as it turns it's picking up the starboard side and pulling down the port side. The boat is so light (1400 lb) it doesn't take much. (L 17' 8" x W 6' 7") I would bet all of...
  9. alldodge

    3 or 4 blades Crownline 180BR

    Maybe First need some numbers. What is current WOT RPM? What is the pitch of current prop? Do you know what the drive ratio is?
  10. alldodge

    Mercruiser alpha 1 gen 2 alarm sounding

    Welcome Looks like your over heating When was the last time the impeller was replaced?
  11. alldodge

    2022 Viaggio Del Mar 18 C. Outage of gages and switches

    Fuel gauge normally works off ignition key, but with all the other things not working look for a wire that is disconnected from battery.
  12. alldodge

    Tonneau Cover

    Dimondback is nicely made but loosing good access to the front part of the bed is no good. My truck is about 5ft up, can reach over but need a ladder to get to anything else
  13. alldodge

    1988 mercruiser 5.0 alpha one

    You said starting fluid would not help to keep it running, which tells me your loosing spark It's not the coil Might be the ignition switch. Measure voltage at the coil to see if 12V is dropping
  14. alldodge

    Bildge pump removal

    Most likely their are screws, use your phone camera and take a vid
  15. alldodge

    150 Four Stroke MAP sensor

    What codes were found This being a Verado/Seapro do you have a AGM battery for starting?
  16. alldodge

    150 Four Stroke MAP sensor

    The serial number comes up as a seapro model and standard model Your parts are HERE The service manual for all models is 8M0168224 Parts and other manuals are HERE The MAP sensor is item 14 and requires removing 1 screw (item 12) and would take all of 5 minutes. Most of the time would be...
  17. alldodge

    Tonneau Cover

    Weather Tech makes good stuff and USA made, and also Husky makes truck stuff and been USA made for years longer and cost less. There are a lot of vendors out there and even the Mopar one looks good, but Mopar doesn't make there own Talked today with a guy who had a Retrax powered retractable...
  18. alldodge

    150 Four Stroke MAP sensor

    Welcome If you can provide the motor serial number we can look up which manual is needed
  19. alldodge

    1988 mercruiser 5.0 alpha one

    Welcome Check for spark Could use a motor serial number but being a 1988 it's most likely you have TB4 ignition
  20. alldodge

    Tonneau Cover

    There are so many to chose from. Might go with a cheap one until I find what I'm looking for. How do the soft folding ones do at highways speeds folded open? I do like the fiberglass look
Top