Search results

  1. alldodge

    Water in Oil

    Not the drive, maybe on the exhaust but you said they are new. Pull plugs and see if any water is found on the plugs
  2. alldodge

    Water in Oil

    First suspect would be the intake gasket Next, was thread sealant used on head bolts?
  3. alldodge

    Volvo Penta OBD port

    RINDA Rinda makes the Techmate Pro and Diacom software, both need adapters to connect to motor. Each version of a motor may need a different adapter. Use their selection tool and it will show which ones will work
  4. alldodge

    Volvo Penta OBD port

    They have a port but the standard auto OBD can not scan the motor. Need something from Rinda
  5. alldodge

    1969 OMC gears, are they case hardened?

    All gears are hardened otherwise they would wear out real fast
  6. alldodge

    2 beep then constant alarm Mercruiser 4.3 mpi

    Normally they last longer then that, unless something like a plastic bag gets caught on drive, sucked up some sand, to many rpms when run on a hose
  7. alldodge

    2 beep then constant alarm Mercruiser 4.3 mpi

    Has the impeller been replaced? 23-2061 is low water pressure
  8. alldodge

    mercruiser trim pump connector leak

    Right now without more research, probably part of the connector If it was mine, I would take apart the connector and find o ring. Then find the 20 cent o ring and replace it
  9. alldodge

    mercruiser trim pump connector leak

    It happens, but Item 7 uses item 8 o ring but that is not the o ring I was talking about. Being there was a leak and you not mentioning where the leak was, I assumed it was between item 7 and the quick connector. The quick connect also has a o ring inside that seals the 2 pieces.
  10. alldodge

    mercruiser trim pump connector leak

    No not that one, it's a O ring that is part of the quick connector the clicks on to that fitting Merc made this so it's easier to dealers to install the unit and get it out the door. They did not do it for a better connection. You could remove all quick connects and reconnect with hard fittings...
  11. alldodge

    mercruiser trim pump connector leak

    Should add that there is a O ring that may just need to be replaced
  12. alldodge

    mercruiser trim pump connector leak

    Yes the fitting can be replaced it's item 7 in link below https://www.mercruiserparts.com/bam/subassembly/30969/11210/170
  13. alldodge

    Sensor 496 HO 2007

    Amazon is ok in most cases but not all. Make sure the place has had a lot of time selling
  14. alldodge

    mercuiser 888 wont idle below 1000 rpm

    Compression test and then leak down test See if you can rent a leak down test gauge, then need compressor and air chuck for cylinders
  15. alldodge

    mercuiser 888 wont idle below 1000 rpm

    You cannot
  16. alldodge

    Sensor 496 HO 2007

    Thanks, you have a 555 ECM. Can get you closer if you can say what kind of beeps. There are some constant, 2 beeps a minute, and others
  17. alldodge

    Merc 300 Bravo slips out of cruise

    Good news, and thanks for coming back and updating
  18. alldodge

    mercuiser 888 wont idle below 1000 rpm

    So far signs are not showing a simple answer. If you hadn't said the motor was torn down and put back together, carb rebuilt I would advise to do just that. If power valve is leaking then this would cause excess fuel, but so would a mis-adjusted carb do same thing. Back fire is caused by...
  19. alldodge

    Sensor 496 HO 2007

    No, in order to find out what the beep... beep is need to connect a scanner to the motor. RINDA Not knowing what your serial number is I'm guessing as to what ECM you have. Is it several beeps, constant one beeeep, some many beeps it stops then starts again or other?
  20. alldodge

    Sensor 496 HO 2007

    ok, that's the IAC (idle air control) valve item 38 https://www.mercruiserparts.com/bam/subassembly/31828/13882/70
Top