Search results

  1. tpenfield

    Help understanding survey conductivity ratings

    Hard for us to provide much more advice, not fully knowing the details (what boat is this?). It would appear that the surveyor is identifying the moisture, but not considering it critical or a show-stopper. Post up the report w/ personal information redacted, if you like.
  2. tpenfield

    Ruined Engine

    Do the easy stuff first . . . People often get too much exercise by 'jumping' to conclusions. The Easy stuff: Mechanics stethoscope of source of noise Compression test Cylinder leak test Remove valve covers to visually inspect rocker arms/lifter rods/cylinder heads Check oil for signs of...
  3. tpenfield

    Help understanding survey conductivity ratings

    Marine surveys have a lot of 'boiler plate' in them that essentially protects the surveyor from repercussions in case something is overlooked or more significant than stated. It's a normal thing. I usually focus on the findings and recommendations sections of the survey and decide for myself...
  4. tpenfield

    Help understanding survey conductivity ratings

    Translating to normal speak . . . The swim platform showed higher levels of moisture around the fasteners The transom show higher signs of moisture The stringers, where accessible, showed signed of elevated moisture, but there were no signs of delamination. There was some percussion testing of...
  5. tpenfield

    Gas leaking from tank inlet

    full tank + vapor pressure = overflow
  6. tpenfield

    Maybe my turn for new boat time

    Wow . . . nightmare. Hopefully they will get it sorted out. It might be between the dealer and Mercury, but you would think Chappy would know how it should be set and do it at the factory.
  7. tpenfield

    Gas leaking from tank inlet

    Is the boat parked on level ground or is the bow slightly uphill? Agree the vent may be clogged, but that may have shown up during the water test.
  8. tpenfield

    . . . and I Thought Hi-tech Boat Engines Were Bad . . .

    I appreciate the input and comments. Keep 'em coming. :D Quick update . . . I found a few threads on the BMW forum about the keyfob 'receiver' not working when the car is warm/hot from sitting in the sun. I'll have to keep an eye on this, but yesterday afternoon (hot sunny day), the fobs...
  9. tpenfield

    Am I just nuts???????

    As stated, not sure you could actually restore & flip the boat for a profit that would fund the next adventure down the rabbit hole. But, You've done a few restorations, so you are in a good place to judge. Assume that you are going to fully gut the boat, so how it was originally built does...
  10. tpenfield

    Home Renovations - Weather Permitting

    Milestone Update . . . It has been a long time coming (will be 3 years in December), but I achieved a major milestone on the house renovation project this week. All the trim repair and painting is done. A quick re-cap of the last couple of years. . . Paint scraped (pressure wash) the house...
  11. tpenfield

    . . . and I Thought Hi-tech Boat Engines Were Bad . . .

    I've been on the BimmerFest forum the past few days. Just learned that a sensor for the keyfob is located in the center console behind the cup holders. I placed the keybob there and the car starts up. Got to try the other keyfob as well to see if there is some consistency. Still trying to...
  12. tpenfield

    Mercury 350 MPI shutting off

    Lanyard switch becoming intermittent. Key switch leads loose.
  13. tpenfield

    briefly overheating

    OK, post a picture of the engine 9if you have one handy) for verification 'fresh water cooling' often refers to closed cooling, but just to be sure. Also, you will need to know if you have the Alpha outdrive or the Bravo outdrive, because the impeller is located in a different place. Also, is...
  14. tpenfield

    . . . and I Thought Hi-tech Boat Engines Were Bad . . .

    OK . . I've been looking into the recurring fault codes. Here is a new one to me . . . LIN ( Local Interconnect Network ). Apparently it is a low cost network used in cars instead of a CAN Bus network. There are master and slave nodes on the LIN Bus. The LIN bus does connect to a CAN...
  15. tpenfield

    . . . and I Thought Hi-tech Boat Engines Were Bad . . .

    Yes, but I replaced the battery - still does it. my F–150 does have a key though :D
  16. tpenfield

    . . . and I Thought Hi-tech Boat Engines Were Bad . . .

    We took the car to NJ this weekend to visit some college friends. The car made it there and back. The door lock thing seems to have stopped, so it must have been a water/moisture thing. The keyfob still does not like to start the car, so I have to hold it next to the steering column and then...
  17. tpenfield

    Help! I need to know what I got!!! Lol

    I was not aware that I had an apparent financial status. :unsure: Please share that with my Admiral, as she is constantly reminding me of our poverty. :LOL: I do enjoy helping folks on this site, as I am helped by many. I often take an interest in researching the lesser know boat companies...
  18. tpenfield

    Russian spacecraft crashes into moon

    Not sure the metric system vs. the imperial measurement system had anything to do with the moon landings, but here is a link to a summary of landings. https://en.wikipedia.org/wiki/Moon_landing Ford vehicles have been metric fasteners for a while. I don't really care what system is in use . ...
  19. tpenfield

    496 HO Failure

    A fair amount of possibilities if the engine was run low on oil. Connecting rod bearing and crankshaft bearing damage comes to mind. Just wondering if the owner noticed low oil pressure while running. You could do a cylinder leak test, just to see if it reveals anything more than the...
  20. tpenfield

    Glastron vs FourWinns with the consolidated plant

    Maybe you should get yourself a factory tour at the factory in Cadillac, MI and see first hand. Keep in mind that combining things into one factory would allow for some economies of scale for common processes (like upholstery, engine installation, etc.) but the boats would still be of their...
Top