Search results

  1. flyingscott

    fuel leaking from weep hole

    That Is NOT an accelerator pump. it is the cold start primer nothing more.
  2. flyingscott

    1981 Evinrude 35hp tiller conversion kit?

    Cheapest thing would be find a parts motor.
  3. flyingscott

    1977 Johnson 35 HP 35EL77H-Rectifier and starting battery recommendation?

    green stator is the charging stator
  4. flyingscott

    1977 Johnson 35 HP 35EL77H-Rectifier and starting battery recommendation?

    do you have the green stator?
  5. flyingscott

    Need help with remote control Evinrude 9.9 setup

    That is it. Forget about finding electric choke parts. Adapt a primer off of a different motor
  6. flyingscott

    Need help with remote control Evinrude 9.9 setup

    look under the stator plate, should be a tab with a threaded hole in it. You have the harness off of a larger engine. you probably don't need the purple wire.
  7. flyingscott

    Need help with remote control Evinrude 9.9 setup

    Put up a pic of the screw. Is it the screw with the pin through it?
  8. flyingscott

    25hp Evinrude

    No you need to redo the compression test. the excess oil can make bad compression seem good.
  9. flyingscott

    25hp Evinrude

    Your gauge is probably good. You can't put oil in the cylinders then do a compression test. Wait a day for the oil to settle and re do the compression test.
  10. flyingscott

    Yamaha 703 control adjustment advice

    Remember the shift cable moves 2 ways. the throttle cable does not.
  11. flyingscott

    Mecury BlackMax 175Hp, Constant Beep and Overheating

    That tells you your thermostats are working. Get an infared gun to double check the actual temps. The switch should be in the head itself If I remeber right. Dukedog or Fatzbullet will be much more help on that.
  12. flyingscott

    Mecury BlackMax 175Hp, Constant Beep and Overheating

    If that is a 2.5 , the tell tales do not fully flow until the thermostat opens. I believe those have 140 degree thermostat so yes toasty water comes out. Not all Motors plumb the tell tales that way. That is kind of a Unique feature to some Mercury 2 strks.
  13. flyingscott

    25hp Evinrude

    That is a false reading, they came factory with around 130psi. Let it sit overnite and re-do the compression test.
  14. flyingscott

    Mecury BlackMax 175Hp, Constant Beep and Overheating

    So if it is the newer 2.5 litre your tell tales will be warm/hot as they are connected to the Thermostats.
  15. flyingscott

    Yamaha 703 control adjustment advice

    Did you reverse the cables?
  16. flyingscott

    Mecury BlackMax 175Hp, Constant Beep and Overheating

    Was the old impeller in 1 piece? did you check the sensor itself? Do you know if that is a 2.5 litre? If not somebody here might know.
  17. flyingscott

    Unable to pull stater rope

    How do you know where the bearing is bad? A bad pinion bearing will cause the problems you are having. If you remove the lower unit and the hard spot stays , you will know the problem is in the powerhead. Either way something in that motor/lower unit needs to come apart.
  18. flyingscott

    Unable to pull stater rope

    You realize you don't need to hit anything for a lower unit to go bad right? Many a bearing goes bad without hitting anything.
  19. flyingscott

    GLSTA 115 Low rpm idle

    You adjust the idle by adjusting the low speed timing.
  20. flyingscott

    fuel leaking from weep hole

    You need a new primer diaphragm. Wouldn't hurt to rebuild the whole carb.
Top