Search results

  1. Grub54891

    Connect boat to house line

    Please explain number seven. There is known cases of people getting electrocuted jumping in the water. If you have seen some of the wiring jobs I have, you would think twice about that statement.
  2. Grub54891

    Deckliner VIP bilge pump?

    If it's under the motor, it may have to be abandoned. you can attach a new one to an alunimum flat bar and slide it down there in it's place. If it gives issue, just slide it out. I usually fix the end sticking out to the stringer with ss screws.
  3. Grub54891

    Connect boat to house line

    I assumed it has two 30 amp inlets. You can use them separetly or both at the same time.
  4. Grub54891

    Connect boat to house line

    Yup my house has that issue. Things work fine but sometimes not. I re-wired them correctly. On a boat it's for safety, if it's wired wrong and not seen it can electrocute someone who falls in the water.
  5. Grub54891

    Connect boat to house line

    I think it's the panel in the boat? They have a reverse polarity light on the panel. Very possible the outlet in the house is wired incorrectly.
  6. Grub54891

    Hey Newbies

    I did the same thing, jb'd the crack on the stb side on my 120. 5 years ago, still running strong.
  7. Grub54891

    Transducer question

    make one out of wood dowels, closet sized or maby a bit smaller. When you get the setup you like, duplicate it in metal.
  8. Grub54891

    Radio turning off at certain volume

    Also, try disconnecting the blown speaker.
  9. Grub54891

    470 front pully removal

    i should have been more specific. What the guy wants to do is replace the water pump. So I'd imagine the damper has to come off.
  10. Grub54891

    470 front pully removal

    Ok, good. All the advice is taken as i haven't had to pull one off of one of these as of yet. I was sent the picture, and asked how to get it off, and was told it didn't have holes in the damper for pulling. I guessed the pully was attached with bolts but was told otherwise. Reguardless, I have...
  11. Grub54891

    470 front pully removal

    Does this take a special puller? Not mine a friend is asking. Yeah I know about the seals and speedi sleeves.....
  12. Grub54891

    engine stalls when shifting back on forth a lot

    ^^^ This^^^
  13. Grub54891

    3.0l bogging down only under load!

    This one ran good the season before. Customers 3.0. Didn't understand why it didn't now. This is what I found. When I cleaned out the gunk, the bowl had a hole in the bottom also. How it didn't leak I don't know! New carb cured it. He said he uses ethonal exclusively. Don't be this guy.....
  14. Grub54891

    Saftey cut-off lanyard now required by Federal law?

    All three of my 1985,1984 boats don't have the lanyard. I'm grandfatherd in I think.
  15. Grub54891

    remove woodruff from tapered shaft?

    Exactly. I don't think the op understands that.
  16. Grub54891

    remove woodruff from tapered shaft?

    A puller would have been fine.
  17. Grub54891

    '99 2330 with hole in bilge

    Weird one for sure. Is the garboard drain down low where it is on the outside of the transom? I ask as it's possible that there is a dead space under there that only drains when you take out the plug. If the plug is visible from the inside in the bilge pump area then there will be water trapped...
  18. Grub54891

    remove woodruff from tapered shaft?

    You need a puller.https://www.google.com/search?q=Pullers&source=lnms&tbm=isch&sa=X&ved=2ahUKEwiRsPGA2enwAhVMBs0KHYfECn4Q_AUoAnoECAEQBA&biw=1234&bih=660
  19. Grub54891

    Washing interior with boat in slip/water?

    Dawn dish soap works for what alldodge say's, but from my understanding, it encapsulates the oil and it sinks to the bottom. Just use boatwash, enviromentally safe soap.
  20. Grub54891

    Washing interior with boat in slip/water?

    If the bilge pump is working properly, it won't sink.
Top