Search results

  1. R

    Johnson 20 hp. Carburetor problem

    Is the thermostat in place and working properly ?----Might be suffering from the classic 2 stroke lean sneeze as well.
  2. R

    55hp 1969 Johnson

    If water got onto crankshaft bearings there could be major rust / corrosion issues inside the motor.----Head bolt torque is likely 40 INCH LBS.
  3. R

    1991 60hp VRO Evinrude - No Spark

    Unless the motor was modified there is no fuse that can prevent spark if blown.----There is a fuse between the solenoid and the ignition switch.-----If that fuse was bad it would prevent the starter motor from cranking the motor over !
  4. R

    Adjusting the drive and carb linkages on ‘89 90hp

    Any pictures of both motors on this boat ??
  5. R

    Adjusting the drive and carb linkages on ‘89 90hp

    Shift rod height MUST be set to a specific dimension.-----Then when lower unit is installed the " thumbscrew " ( trunnion ) can be adjusted.-----So in forward gear can you turn the prop clockwise but not counterclockwise ??
  6. R

    Anti-Ventilation Plate Height?

    Is this a small kicker motor ?----Power of this motor ?
  7. R

    1991 60hp VRO Evinrude - No Spark

    Part # of the ignition / spark fuse on your motor ?
  8. R

    1991 60hp VRO Evinrude - No Spark

    Are you sure there is a fuse for the spark making system.
  9. R

    Adjusting the drive and carb linkages on ‘89 90hp

    In FORWARD it might spin one way and not the other way.
  10. R

    40hp Dead Top Cylinder

    Lpgc----Nonsense , the 3 cylinder MERCURY you speak of has 3 separate crankcases.---Like al inline 2 strokes each cylinder needs seperate crankcase for compression below the piston !
  11. R

    40hp Dead Top Cylinder

    Do you not want to take the cylinder head off ??----Simple / easy job.
  12. R

    40hp Dead Top Cylinder

    There are 2 separate crankcases.-----The top carburetor is for the top cylinder only.
  13. R

    55hp 1969 Johnson

    The head is warped.----Refinish it to be flat.
  14. R

    Adjusting the drive and carb linkages on ‘89 90hp

    Did you check / set shift rod height ?
  15. R

    I think I killed my TE60TLENE

    Many shops do not rebuild the older / smaller / 2 strokes anymore.-----No call for them and no easy money to be made.
  16. R

    40hp Dead Top Cylinder

    I read post #1 and read many posts.-----It seems the simplicity of a 2 stroke and trouble shooting of them is not well understood !
  17. R

    40hp Dead Top Cylinder

    The 2 stroke engine is a simple 2 stage air processing machine !----Air is pulled into the crankcase through reed valves ( a check valve ) and compressed in the crankcase.-----Then transferred to the cylinder.----When exhaust ports close compression in the cylinder starts.----Reed valve is no...
  18. R

    40hp Dead Top Cylinder

    Reed valves have nothing to do with compression in the cylinder !!!!
  19. R

    1996 Johnson 50 Not starting

    Is the key a factory part ?----Hardware store part ?----Did you torque the nut properly ?
  20. R

    2006 mercury 150 opti-Max

    See your local dealer about availability of parts and factory support for these motors.
Top