Search results

  1. Bondo

    mercruiser 4.3 alpha 1 gen 2 shift issue

    Ayuh,..... I'll move this to the Mercruiser forum for ya,.....
  2. Bondo

    looking for new prop

    Ayuh,.... Welcome Aboard,..... Pull the prop off the boat, 'n find the numbers on it, pitch will be cast or stamped into it,.... 'n yer tach is off,..... Way off,..... Cross-check it with a known good shop tach,....
  3. Bondo

    Alpha one trim wires

    Ayuh,..... The switch, No,.... It's just a make, or break switch,.... I believe the sender has opposite bullet connectors on 'em,.... Though it shouldn't matter anyway,....
  4. Bondo

    Outdrive does not want to re -install in boat

    Ayuh,..... Welcome Aboard,..?? Did you check the gimbel bearin' to coupler alignment,..??
  5. Bondo

    Alpha one trim wires

    Ayuh,..... The trim sender hooks into the wirin' harness that goes to the dash gauge,..... The trim limit switch goes to the pump,....
  6. Bondo

    Engine replacement

    Ayuh,..... Welcome Aboard,..... The wisest way to go is to buy a Long Block replacement, 'n use the accessories from yer old motor,..... By the time you buy a block, 'n con-rod, then have the required machine work done, you can buy an already rebuilt Long Block,.....
  7. Bondo

    Yamaha L4 3.0 coolant water blockage in stern drive

    Ayuh,.... Welcome Aboard,..... There's the hose from the transom, the fitting it attaches to, another hose from the transom to the drive, 'n a tube in the drive down to the water pickup at the lower unit,..... I'd pull the drive, 'n see what's goin' on,..... Bein' on the vacuum side of...
  8. Bondo

    Mercrusier Steering "S" Turns

    Ayuh,..... Pretty much all V-hulls with outdrives do it,.....
  9. Bondo

    3.7LX Mercruiser 6916779 manual

    Ayuh,..... Welcome Aboard,..... Have a look in Here,....
  10. Bondo

    Question

    Ayuh,...... Welcome Aboard,..... Where does the yellow wire go too,..?? I believe the screw it's hooked to is ground,....
  11. Bondo

    More distributor trouble.

    Ayuh,.... Welcome Aboard,...... Yer post seems to be missin' alotta words,..... What's the problem,..??..??
  12. Bondo

    Best manual stapler for replacing carpet on bunks ?

    Ayuh,....I use a T-50, 'n follow it up with a few taps of a hammer,.....
  13. Bondo

    23 nova xl 454 98 mercruiser water pump leak

    Ayuh,....... Welcome Aboard,...... That's a combo oil- P/S cooler,..... It probably froze, 'n will probably need to be replaced,.....
  14. Bondo

    Aluminum exhaust elbow.

    Ayuh,..... Is this the riser elbow, or the elbow that turns down into the y-pipe,..??
  15. Bondo

    Tracker Tahoe 202

    Ayuh,..... Welcome Aboard,..... Yes,.....
  16. Bondo

    Flywheel bolt pattern

    Ayuh,..... Welcome Aboard,...... Are the splines the same,..?? Will the bigger coupler clear the flywheel cover,..?? If not, you'll need to find a pre-'86 replacement motor,.....
  17. Bondo

    Mercarb idle speed screw and adjustment

    Ayuh,..... When yer fine tunin' the idle, ya do it on a warm motor, choke off,.....
  18. Bondo

    1989 mercruiser 5.7 ignition

    Ayuh,...... The Shift Interrupt switch,..... That's in the ignition circuit,..... The neutral safety switch is in the controller housin', 'n is in the Start circuit,....
  19. Bondo

    1983 Chris Craft with original Mercruiser 5.7

    Ayuh,.... Was either unit Tested,..?? I'd expect to see close to battery voltage on the excite wire,.... Are the battery terminals, as well as every other wirin' connection Clean, 'n tight,..??
  20. Bondo

    Mercarb idle speed screw and adjustment

    Ayuh,.... Open choke,....
Top