Search results

  1. dingbat

    Audio Warning system disable with Key on engine off for Radio?

    Don't wire your accessories to the ignition circuit. My ignition switch controls nothing but the choke, ignition and the starter motor.
  2. dingbat

    Trailer brake system opinions

    The only thing the conversion would save you is the cost of the coupler less the cost of a break away kit and the associated wiring. Have to swap out the backing plates either way. Probably replace the drums as well if it's been sitting that long. Also need to install and wire a breakaway kit...
  3. dingbat

    run a ground wire

    How do you double the number of wires without doubling the number of connections? I simply drilled and tapped the frame and installed a stainless steel ground lug for each light.
  4. dingbat

    Inaccurate fuel gauge?

    It is accurate but not precise below 1000 rpm. At that point I’m burning roughly a gallon, gallon and a half an hour. Readings are cyclic (wonder if I’m not seeing the carb floats) but total reading at the end of the day falls in-line with expectation and gauge readings The key to reliable...
  5. dingbat

    Inaccurate fuel gauge?

    What type of sender do you using? A perfect ground path (0 ohm) isn’t going to improve the situation if the output of the sender isn’t in spec. Have you put a meter on the output of the sender? Have used a pair of KUS-WEMA senders for 10+years in combination with a Garmin GFS10 fuel flow...
  6. dingbat

    Surge Brakes

    Working properly, you should hardly notice them working. Trailer shouldn’t “push” the truck. Truck and trailer should stop as a pair My disks will blister your finger in a couple miles of leaving the house
  7. dingbat

    Buffing the hull

    My boat turned 24 in April. Have used nothing but Collinite Fiberglas cleaner followed up with two coats of 885 Fleet Wax twice a year since new. Both applied by hand up until a couple of years ago when I finally bought a variable speed polisher. Was given a bottle of Smoove “bubble Gum”...
  8. dingbat

    Evinrude XP-150 Trim has no power

    Meaningless..... its a surface charge. Easy test.....measure battery voltage while trying to use the trim function. If the voltage drops you have a bad battery or trim motor. If the voltage doesn't change, there is something open (fuse, switch, relay, wire) in the circuit.
  9. dingbat

    Evinrude XP-150 Trim has no power

    60% charged means absolutely nothing...... A bad battery with a 60% charge is still a bad battery. You need to load test a battery to determine it's actual condition. Yes, trim motor are replaceable. Had to swap mine out this Spring.
  10. dingbat

    Evinrude XP-150 Trim has no power

    What was the actual voltage you got? A 12V battery is 12.7V fully charged. By the time its reaches 12 volts you effectively have a dead battery
  11. dingbat

    Salt Away?

    The entire surface of aluminum is covered with aluminum oxide (alumina). It is harder than the aluminum itself. Used as grit on sand paper. Aluminum Oxide causes bolts to stick and the white "acne" you see on the surface of "corroding" aluminum, but it's not the powdery accumulation that...
  12. dingbat

    Salt Away?

    http://www.saltawayproducts.com/How%20Salt-Away%20Works.htm No commercial product or other liquid substance can move salt crystals from a surface by the act of dissolving them. The salt crystals, in solution, must physically be moved off the surface at obvious exit points. Salt crystals...
  13. dingbat

    Old propeller problems

    https://72land-n-sea.blogspot.com/2012/07/aquamatic-propellers.html?m=1
  14. dingbat

    Need new gunnel rod holder pieces?

    https://www.greatlakesskipper.com/bayliner-boat-fishing-rod-holder-1718354-arctic-white-pair
  15. dingbat

    Salt Away?

    http://www.saltawayproducts.com/MixerPage.htm
  16. dingbat

    Old propeller problems

    What motor do you have?
  17. dingbat

    Accessories don't work when boat in water

    You don’t remove any wires to check ground. Check for continuity between the battery or accessories panel ground and the hull. There should be no continuity. If there is, you have a grounding issue not related to your power problem. Have you put a meter on the power connections at the...
  18. dingbat

    Old propeller problems

    Most mfg. have gotten away from fixed hub props and gone with interchangeable hubs. Lots of 14 x 14 props on the market. Just need to find a 12 spline insert to go with it https://www.rubexprops.com/propulsion/propeller-hubs/
  19. dingbat

    Strange tach behavior on a Penta 5.0L

    From the looks of it, (brass gulling) the hub wasn't tight and the insert is spinning on the thrust washer. Far end of the plastic sleeve looks like it's been hot at one time or another as well
  20. dingbat

    08' Honda 150hp 4-stroke Heat Alarm

    Is it over heating in the water or on muffs? Buddy has one that fine on muffs. The other overheats on muffs
Top