Search results

  1. C

    Flat tire on haul-out today . . .

    Your post reminded me to check the tire pressure on my two trailers., as it approaches time to pull 'em. The speedboat trailer had 50PSI and called for 80PSI. I filled it. The 21 footer tandem trailer was fine at near 50PSI. I also was inspired to spray the rusty parts of the trailer with...
  2. C

    Switching mercruiser throttle controls

    I would expect the new controls to work mechanically. There should be a listing of compatibility, but if the OD is Alpha, and the new control fits Alpha, I would expect it to work. The electrical connections could be a bit different.
  3. C

    making your own gaskets / seals

    All the leaks in the waterpump base I have ever had were from the driveshaft seal. The base gasket and Oring did not leak, as far as I could tell. My V6 Merc has needed two shift shaft seals in the last decade.
  4. C

    Are these old D!ck Pope Water Skis any good?

    I just tossed out a pair of pope skis a month ago. They were fine, even with the orig bindings (heavy vinyl I think). I could not give them away. They were fine to ski on, as the flat bottom of the ski gave good action on two skis. I also tossed out a "Banana" slalom ski. it had a concave...
  5. C

    1992 150hp XR6 gauge setup

    Your trim gauge sender wiring must be wired up thru the transom clamp. The way it is now will likely cause it to be physically damaged by the water. I never saw a water pressure gauge sender like that. It sure looks like a water temp gauge. A lot of Merc V6 motors had an overheat switch on...
  6. C

    Prop problem

    Remember the internet is still insisting that perpetual motion machines are real. They want the clicks, likes and subscribes, for the $$. Actually, I think you can find most any alternate fact on the internet, without looking too hard. (BTW- alternate facts are lies.)
  7. C

    No Spark after Stator Replacement

    Bad rectifiers can cause spark issues. Disconnect the rectifier AC leads, insulate them and then retest DVA voltage.
  8. C

    End of Season oil changes?

    Gee, checking the gearcase for water infiltration at haul out, is just a bit less work than changing the gear oil at that time. At least IMO. I just change it.
  9. C

    making your own gaskets / seals

    Make sure the Oring under the pump base fits properly. I think most of the sealing occurs there.
  10. C

    Barefoot skiers?

    John, on an unrelated note. We always used ski belts, mostly because jacket - style life preservers were not widely available, and the belts satisfied the regulation. On one skiing trip about 50 years ago, a high school friend of mine, skied in her bright orange bikini, with it's 4 fabric...
  11. C

    Mercury 2-Stroke Oils

    DFI motors inject oil into the crankcase, via an oil pump. Air only is drawn in to the crankcase by the piston movement, as is usual for a 2 cycle engine. A V6 Optimax OB, for example, has 7 oil injection points. One for each cylinder, plus one for the air compressor. Since the DFI oil is...
  12. C

    What is this wire hanger called and where can find a replacement?

    Those style hooks are pretty widely avail, in different sizes. It is likely Amazon will have some.
  13. C

    Modern PT lumber

    The pilings that Venice is built on were whatever was available in Europe at the time. They were a mix of soft and hard wood. They were driven a foot apart or less, and were of different diameters and lengths. The key was to drive them to the water level, and top them with waterproof...
  14. C

    Modern PT lumber

    Cedar is very rot resistant, and superior to pine in several ways. If PT pine was not a lot cheaper that cedar, it would not be used, IMO. As for Chestnut, I do not know how long it resists rot, if it is used for a deck, but if used for the walls of a roofed barn, I am pretty sure it will last...
  15. C

    Add tilt/trim to 1978 Mercury 500 Thunderbolt 50HP 4967035

    Gee, like the CMC brand unit?
  16. C

    Modern PT lumber

    Your barn has a roof, right? That keeps most of the water off the chestnut logs, helping them to last, although hardwood is more rot resistant. My neighbor built his deck with Mahagony. It looked like crap, but didn't rot, at least not yet.
  17. C

    Add tilt/trim to 1978 Mercury 500 Thunderbolt 50HP 4967035

    Gee, I do not know what an "Outboard bracket with tilt and trim", is. I think he would need a midsection compatible with the powerhead mounting bolts, with a transom bracket with an integrated PTT unit. I have heard that those exist, I do not know which models and years would bolt to his...
  18. C

    Modern PT lumber

    I have heard that there is PT hardwood, however, I have never seen it.
  19. C

    96 mercury elpto plug questions?

    Gee, punch up a Mercury parts site like crowleymarine and see what they recommend.
  20. C

    Add tilt/trim to 1978 Mercury 500 Thunderbolt 50HP 4967035

    The crowleymarine web site should have the part numbers for the PTT system. I expect you will need two PTT brackets that hold the top of the cylinder, a pump/reservoir that mounts in the boat and 4 hydraulic hoses to power the PTT cylinders. The electronics are pretty easy to wire up from...
Top