Search results

  1. alldodge

    HOW TO FILL POWER TRIM ON 1982 50HP MARINER NO RESIVOR ON PUMP INSIDE OF BOAT CYLINDERS ON EACH SIDE OF MOTOR

    This is the standard for marine equipment. Look under the cowl for a plate riveted to to the base.
  2. alldodge

    OMC STINGER 351 MISSING

    Welcome OMC has been out of business for years. I would rebuild the transom and replace with a Merc motor and drive. Should be able to find a rotted out hull with a good motor
  3. alldodge

    trolling motor assembly

    Welcome Would be good to post a pic showing the brushes so we could have a better idea of how to do it. A trick I've used is string. Tie the brushes back using string, then when armature is installed cut and remove strings. Don't know if this would work in your case because I would need a pic
  4. alldodge

    Rethreading tie down strap buckle.

    Unless there setup and never adjusted again I would choose another type, but just me For others that would like to know how it's threaded https://strapstogo.com/buy/1-inch-304-stainless-over-center-buckle
  5. alldodge

    Need a bimini top replacement for my 358 Vista

    Welcome In most cases it's easier to go to a local canvas shop and have them make you one, or do the repairs
  6. alldodge

    Rethreading tie down strap buckle.

    Reminds me of a 2 slot scuba buckle, but the scuba buckle requires another web strap to come in from the other side
  7. alldodge

    water pressure vs air pressure

    PSI Pressure from water or air is the same, only difference is air may leak out some place where water would not
  8. alldodge

    Another prop slipping thread

    What do the splines inside the coupler look like?
  9. alldodge

    1999 Force/Merc 75HP 3 Cylinder 2-Stoke Rough Running Issues

    Folks a side track question. Comment came into the Mods that this is a Force motor and not a Merc. It does look like a Force, and Force was made by US Marine for Bayliner until 1999. What say you?
  10. alldodge

    Staying warm on boat in the winter

    I don't know of a way that wouldn't cost a bunch or be noisy, both would use a 400 watt electric heater. Don't know how long power will be needed Noisy - Get a 1000 watt gas Gen (under $200) and place it on the swim deck Costly - Get a LiFePO4 Battery ($1000) to power the inverter, don't use...
  11. alldodge

    What rifle to scope for hunting?

    Folks looking for ammo do use ammoseek.com to check Nothing to do about a license to hunt, has to do with able to have "full auto"
  12. alldodge

    Fuel line upgrade

    Agree with DingBat, use some A1 fuel line and you will have no issues
  13. alldodge

    Hunting - tips for old beat up guys like me ;)

    They make one but appears to be open cab, look at 1140 model
  14. alldodge

    What rifle to scope for hunting?

    Don't see an issue "IF" you have a license
  15. alldodge

    Hunting - tips for old beat up guys like me ;)

    Has spray in bed liner, hydraulic dump bed, heat, AC, and hydraulic rear connections to run other things like a post hole digger Also use it to take me seadoo up and down a 1/4 mile stretch down to the lake, and road is steep
  16. alldodge

    Water leak into bilge

    If motor is cracked, freeze plug is missing or Y pipe has a hole it will leak just sitting in the water. Need to find where it's leaking. Take it to a shop and let them find it for maybe $100 to $150 Pulling motor $500 to $1000, depends on where you are
  17. alldodge

    Hunting - tips for old beat up guys like me ;)

    Bought a Kubota RTV 1100 diesel in 2016 I think and never any problems, use it about every day for short trips. Still original battery, like dang that is unusual
Top