Search results

  1. alldodge

    Ignition problems! Please help

    Check for 5V with ignition ON, motor OFF Check on one of the 5V sensors like MAP, TPS, Temp
  2. alldodge

    2011 4.3 Alpha MerCruiser winterizing question

    You could blow air into the hoses to see if anything else comes out, would be no issue. Taking a run around the block IMO would have little effect if any.
  3. alldodge

    Mercruiser A1 G1 140HP Upper Gear housing Question regarding heat..

    I wouldn't worry about it
  4. alldodge

    2011 4.3 Alpha MerCruiser winterizing question

    Should be good Still don't see the 5 blue plugs with a single point, but the more drain plugs pulled the better
  5. alldodge

    2011 4.3 Alpha MerCruiser winterizing question

    ok that's different then what I thought with 5 blue plugs You have only one plug https://www.mercruiserparts.com/bam/subassembly/31503/13808/200 In that case, your playing with maybe's Maybe all the water drains out, and maybe it doesn't Fresh water boats have less of a chance to not drain...
  6. alldodge

    2011 4.3 Alpha MerCruiser winterizing question

    For open cooling it shows 7 point (7 blue plugs) Or single point drain I need a pic of this handle
  7. alldodge

    2011 4.3 Alpha MerCruiser winterizing question

    What is the motor serial number?
  8. alldodge

    Mercruiser A1 G1 140HP Upper Gear housing Question regarding heat..

    Depends on what "hot" means HOt to touch but not burning your skin, I wouldn't worry about it. The exhaust runs thru the drive and your on a hose
  9. alldodge

    Prop not turning when in gear

    Moved you to OMC, it's not a prop issue it's a drive or cable issue Lower shift cable is disconnected/broke/out of adjustment Does shift plate move when throttle is moved FWD/REV?
  10. alldodge

    2011 4.3 Alpha MerCruiser winterizing question

    Don't of any vids I would recommend, but it's fairly easy Not getting into the oil change or other stuff, just winterization of motor Remove block drains on each side of the block. Use a screw, nail or wire to push up inside the hole to make sure nothing clogs drain hole Remove exhaust...
  11. alldodge

    1995 Regal Commodore 272 water tank Q

    The tanks use a float with reed switches, and pressing the water or holding tank buttons sends power to that float. Need to check for 12V to the push button switches
  12. alldodge

    Micro commander

    I've never messed with one, found the manual https://www.straathofcontrols.com/media/pdfs/314-580-585_MM14075_RvB_10-01_.pdf
  13. alldodge

    Volvo Penta 2003 Injector Sleeves

    Welcome If VP says they should be replaced, then my guess is yes. That said, you can try to use old ones and if it works out your good. Don't know what motor but if injectors are easy to get to then might be worth a try
  14. alldodge

    Mercruiser 4.3L lift points

    I hear the sound but no pic/mov
  15. alldodge

    Bayliner Capri 2150 resurrection.

    Guessing "Had" is have right? You could do it, not that hard
  16. alldodge

    Intermittent electrical problem Mercruiser 3.0

    Welcome And the 2 Mech you found don't go back to them, especially the 2nd. First replaces starter and 2nd does same thing, good grief My first guess with on/off and no power is the key switch, next would be bad connection. Easy to find with a voltmeter
  17. alldodge

    VSR vent line full of fuel

    We're back were we started. The only way fuel comes into the clear hose is if pressure is to high, needle and seat not stopping fuel or float level is set to high
  18. alldodge

    Little bit of help needed

    Wow, 3 stats
  19. alldodge

    Trailer winch bow anchor repair

    I'm with Scott have it welded, good welder can make it stronger then it was originally
  20. alldodge

    06 Mercruiser 5.0 MPI no power above 2000 rpm - thoughts?

    Thanks for the SN Yes you should have a in-gear switch on the shift plate. Try disconnecting it and see what it does
Top