Search results

  1. R

    Force 120 1976 - Was running great, then gradually lost ability to idle. - Need Help Please

    The compression values are an issue.-----Remove cylinder head and have a look.-----It could be a bad head gasket .----Or scored cylinders that will make you cry at an estimate to repair.
  2. R

    1989 88hp set timing on muffs to tdc

    Try another timing light ?
  3. R

    Sharrow prop

    Props / horsepower / boat speed / changing characteristics of water with speed / salt water / fresh water / drag of boat hull / twin vs single engine / 2 or 5 blade props .-----The mystery will never go away.
  4. R

    1995 Evinrude 50 hp

    Post the compression values.----And does spark jump a gap of at least 3/8" on both leads, yes or no?---Was there a lot of dirt in the carburetors ?----Perhaps check for a sheared flywheel key.----Is VRO in service and checked ?----Or mixing at 50:1 in your tank?
  5. R

    Popping and shaking

    It has a starter motor.----I assume it has a stator to charge the battery.----I believe you should install a battery to protect the battery charging bits !----Do not run it without a battery in the circuit.
  6. R

    Popping and shaking

    How does it run when boat is floating in water?-----Use a timing light to look for an ignition miss if there is one .----Perhaps throttle plates open too early.----Have you tried adjusting low speed mixture screw?----Thermostat in place and working properly ?
  7. R

    New issues on engine

    Replace gasket on the water jacket cover.
  8. R

    Sharrow prop

    People are easily fooled.----Just ask folks who invested it --" bitcoin " and other electronic money scams.
  9. R

    1969 25 Hp Johnny Rude/Kicker?

    Thermostat stuck open ??----Best have a look at it and test it.----Very simple.
  10. R

    1994 Johnson 115hp, V4…Tilt Trim question?

    Remove clip.-----Then remove manual release valve.----Check seals on manual release valve.-----Easy step to take.
  11. R

    Recoil pawl evinrude 25 hp

    Pictures of the flywheel ?
  12. R

    Recoil pawl evinrude 25 hp

    After 1984 they went to 2 pawls.----As you have found one pawl is not hefty enuff.-----Also make sure rope is correct length to time the pulley !!-----The sheave is oval for a reason.
  13. R

    Recoil pawl evinrude 25 hp

    Early motors used only 1 pawl.----A tough job for one pawl.-----So they went to 2 pawls.----Recoil was also mounted with rubber mounts so thar housing could flex and share load on the 2 pawls.-----I recommend you use 2 pawls, but it is up to you to act.
  14. R

    Merc 4 stroke worn out with low hours

    I will take a 1960's or 1970's OMC 6 HP any day.-----Far better and more reliable than some 4 strokes.
  15. R

    Recoil pawl evinrude 25 hp

    0330525 available all day long.----Are there 2 on your motor ?
  16. R

    Merc 4 stroke worn out with low hours

    What HP ?----Is it a 6 HP ?
  17. R

    Ignition plate hold down evinrude 25 hp

    Post about 8 pictures of this motor and the damage caused under the flywheel.
  18. R

    Ignition plate hold down evinrude 25 hp

    Picture of the cowling if original?
  19. R

    Ignition plate hold down evinrude 25 hp

    Perhaps it is newer ?
  20. R

    Ignition plate hold down evinrude 25 hp

    Doubt that the above picture is the same as the subject motor.----Model # should be posted.
Top