Search results

  1. R

    Are press-in rubber hubs still obtainable?

    The rubber hubs are not easy to install unless you have a press and the tapered guide.-----When you see a new hub and the hole it has to go into you might say.-----" How is that possible "
  2. R

    Fouling spark plugs

    A 2 stroke motor in good condition will idle / troll all day long.----And run full throttle the next day all day long !!!-----I used to troll with a V-6 Johnson 235 HP.----Hours at a time and no sparkplug fouling issues.
  3. R

    1999 Evinrude 50 hp four stroke

    ???----What happened ?
  4. R

    4.5mercury wont start

    Easy to take carburetor apart for inspection !-----Maybe tap the carburetor with a hammer ( piece of firewood ??).-----When you operate the manual pump you are also testing.-----Fuel MUST flow to the motor ( 3 or 4 pumps ) when you operated the bulb.------If that does not happen something is wrong.
  5. R

    The newest outboard from Mercury

    Four of these monsters will replace 5 or 6 of the 350 / 450 HP motors.------One of the features ( not cheap ) on these motors is the " fly by wire " of throttle / shifting / steering systems.----Clean installations.------Not cheap but so convenient for the folks in these snack brackets...
  6. R

    4.5mercury wont start

    Some trouble shooting required on your part !!-----You could put a few drops of fuel in the cylinder through spark plug hole.----Try and start it and report if it " barks " for you.----Carburetors are simple / easy to inspect and repair.
  7. R

    Fouling spark plugs

    Nope----When in good condition a 2 stroke will idle all day long !!!------And run full throttle for the next day too !!
  8. R

    Fouling spark plugs

    Is there a working thermostat in your motor ?------What plugs are you using.
  9. R

    4.5mercury wont start

    If carburetor was full of fuel it is likely flooded now.------Pull on the cord , check for spark.-----If you have spark , pull cord ( no choke ) till it starts.
  10. R

    1982 Merc 90 HP not starting

    ??------The propshaft spins at about 1/2 the speed of the flywheel.
  11. R

    1982 Merc 90 HP not starting

    More history required .----Or supply information.-----Remove lower unit and see if it spins easier.------Did motor overheat ?-----How did it run for you last season ??
  12. R

    Air Don't Freeze Winterization

    When you remove a drain plug you have to see water coming out !----If no water you need to poke around with a wire and remove the plug of sand / silt etc.
  13. R

    82 Evinrude 70 hp

    I drove through Regina in early September.-----Not many lakes there.------Post what you find out.
  14. R

    82 Evinrude 70 hp

    Cowling tells me it is an 81 model.----Same as an 82 model as far as parts.-----Checked the fuse ?-----Motor will start with a dead battery using rope on flywheel.------Your location ?
  15. R

    1996 Johnson 150 no spark

    That has the optical ignition.-----Throwing parts at it gets expensive.----A manual would guide you on testing of the components to find the faulty part.
  16. R

    1996 Johnson 150 no spark

    Looper refers to the piston design on your motor.----Sometimes it is of great importance to verify what motor is being discussed !!
  17. R

    1996 Johnson 150 no spark

    Likely a 60 degree looper with optical ignition.------Model # required.
  18. R

    Oil/fuel Question

    The mix was 24:1 on those.-----You will get 10 opinions from 5 people on what you should run today.
  19. R

    Grinding Noise in US Marine Control Box Force 125

    Well-----I think it is the gear shift cable / linkages on the motor that need adjusting.-------So disconnect shift cable at the motor.-----Operate the control box as a test.----Does it still make the noise ??
  20. R

    1984 Johnson V4 90hp max rpm

    I like 5200 / 5300 RPM on those.
Top