Search results

  1. alldodge

    Building a 12V Herbacide Sprayer

    Instead of buying one, I'm looking into building a herbicide sprayer. Have a 250 gallon square tank on a pallet. So need a pump, tubing, bypass valve, wand, tubing and other stuff. Want to put the tank on the Kubota RTV and then have tubing to make a boom to spread out maybe 20 to 30 feet...
  2. alldodge

    4.3 water intrusion

    I think your intake is cracked
  3. alldodge

    thunderboltV module, no spark

    Not knowing what shop manual your using, here is the TB trouble shooting guide As for the gray wire, just remove it from the coil - side
  4. alldodge

    Cannot go faster than 10 MPH, but runs fine in neutral.

    Correct, something overheated and melted. Since your boots are intact, I would say those are what's left of your exhaust flappers. And a clogged exhaust can cause your issues
  5. alldodge

    WTH is the starter solenoid.

    The large wires on top the starter are grounds, the one outlined in red is the main cable from the starter solenoid to the starter. Don't forget the grounds can also cause the starter not to engage
  6. alldodge

    Fault Codes

    Codes can be found here along with troubleshooting http://boatinfo.no/lib/volvo/manuals/wt_efi.html#/2
  7. alldodge

    What kind of prop lock is this and how do I remove it

    Never seen one like that before, looks like it needs some kind of pin spanner wrench. Would also need to hold the key to the center when turning
  8. alldodge

    Trailer Wiring Converter

    You have the colors on the trailer mix by the looks of it Brown - tail lights Green - Right turn/brake Yellow - Left turn/brake White - Ground
  9. alldodge

    Unstable idle

    This is a pic of a throttle body and not a carb, but the adjustment is the same. Also looked at the link and it doesn't play, may need to use youtube
  10. alldodge

    need starting advice

    Not an OB guy and found no wiring diagrams on the newer 4 stroke motors. Maybe my comment will bring out an OB guy. That said Mercury has kept the wiring colors the same. Red - Battery power Purple - Ignition power (key ON) Yellow/Red - Starter Place motor in neutral Now the kill switch is...
  11. alldodge

    Alpha one shift cable adjustment

    OK, and BT made a good point, if its an Alpha its not a Bravo anything. If its a Bravo 1, 2 or 3 adjustment is the same. What does your cable end look like?
  12. alldodge

    Glue bottom of Bilge Pump

    As others have mentioned, sooner or later the pump will fail, and if it's glued, well your stuck :D Either the pump will go out or the float switch. Not knowing where it will be located, but in most cases its under the motor/transmission. If you fasten it to a piece of wood and then glue that...
  13. alldodge

    5.7 L EFI RPM idles high intermittently

    If you can push and it slows down then its as Bondo mentioned, or could be the throttle body is binding
  14. alldodge

    T Bolt Clamps

    I thought T bolt clamps were better then worm clamps and they would last longer. So far two of these have broken the same way. Appears to be metal fatigue. It came off my 08 truck but same things are used on boats. Was thinking of replacing them on the oat but after two I'm having second thoughts.
  15. alldodge

    Mercruiser 5.7 thunderbolt ignition running issues

    Float level depends on which needle and seat you have Spring loaded needle is 3/8 (10mm) Solid 2 piece needle is 9/16 (14mm) Here is bulletin Float drop is 1 3/32 (27mm) Here is your motor http://www.mercruiserparts.com/5-7l-2-bbl-gm-350-v-8-1996-0f601000
  16. alldodge

    OVA DVR to server to house

    Not the same question as in previous threads, but the end result is getting to the same point. Will not be doing any retransmission for others, only self use so the FCC should not be an issue Looking for knowledge to do it or figuring out what other forum would be best to post the question...
  17. alldodge

    Discount code

    IS Forum5 still good or is there another?
  18. alldodge

    2005 mercruiser 3.0 TKS carb...

    The TKS is pretty much the same as the 2GC carb. Once the module has extended to block the enrichment passage it acts just like the 2GC. Power is supplied to the module when the key is turned ON via the Red/Purple thru a 20 amp fuse, and the oil pressure switch supplies a ground to the module...
  19. alldodge

    Battery hooked up backwards. No life! Help!

    Note pic below is newer 4.3, the breaker (item 7) is between the starter and the Red/Purple connection. The Red/Purple connects to the starter slave solenoid (item 8). The 90 amp fuse (not shown) is place between the Orange wire from the ALT to the starter. This is a fuse so it will react...
  20. alldodge

    My first stall and no-start mystery answered... now I need to find the part.

    Never have seen any numbers on the connectors. The pumps are sold by Airtex in model Electric fuel low pressure E11003 Electric fuel high pressure E11004 These are what they look like
Top