Search results

  1. Scott Danforth

    Paint color question

    You may find repop decals on ebay, however you will never find factory replacements as OMC has been out of business for over 25 years. The paint is close enough to Evinrude silver. However your paint has faded over the past 40 years. So any silver will work BTW, your stringer is a left over...
  2. Scott Danforth

    dead battery and hatch is down

    Go under the dash, use a small 5amp batter charger to the red wire on the key switch, and the ground buss bar
  3. Scott Danforth

    E85 in Chrysler outboard?

    Your outboard would go into melt down. Just like small engines. You would have to build a custom fuel system. You have to burn 1.8x the E85 as you do E0 to get the same power. Not worth it
  4. Scott Danforth

    Spreading Manure, again

    Aeronautical Swine Prop Shop.....
  5. Scott Danforth

    Just thought I'd share a nice photo.

    'kogs, check out Chassahowitzka River or Crystal River next time you are in Florida
  6. Scott Danforth

    draft and tilt trailer

    FWIW, some of the ramps I have launched from required to back in until the truck exhaust was bubbling under water and there was water coming in the doors. we later switched to a tractor for launching
  7. Scott Danforth

    Just thought I'd share a nice photo.

    where is your canal?
  8. Scott Danforth

    Mercruiser 470 service manuals

    http://publications.brunswick.com/ you wont find a "link" to anything other than in a scam site today. since Adobe flash went away, boatinfo went away. Boat info would buy a manual and share. however that is also copyright infringement. so the only legal place to get factory manuals is...
  9. Scott Danforth

    2021 Tracker V-16 leaks

    most likely a loose clamp or other issue. usually livewell plumbing is assembled to the deck before its dropped into the hull.
  10. Scott Danforth

    draft and tilt trailer

    back in further
  11. Scott Danforth

    Air Don't Freeze Winterization

    but that guy is the key to BLN - The Boat Launch Network...... a collection of videos of boat ramp follies.
  12. Scott Danforth

    Mercruiser 3.7 / 470 Holley EFI Sniper.

    hope you dont run lean like @todhunter did
  13. Scott Danforth

    1975 Fiberglass Boat Restoration

    normally a transom is 1.5" of wood (38mm ) and 2" total thickness (50mm)
  14. Scott Danforth

    Second Boarding Ladder . . .

    biggest issues with the box ladders is the sealing. also, GG Schmitt patented the box ladder, however China didnt care and knocked it off anyway.
  15. Scott Danforth

    Chevrolet Demon 5,7 l marine engine

    No. while the GM motor is used by most all of the marinizers. you need to have the manual from the marinizer. Volvo Penta, Mercruiser, etc. Chevrolet doesnt marinize motors and Demon is a variant of a dodge dart, or a variant of a holley carb you obviously bought the boat from someone that...
  16. Scott Danforth

    Second Boarding Ladder . . .

    you know you could have bought that pre-made from GG Schmitt. 3 & 4 step flush mount ladders. https://www.ggschmitt.com/boat-ladders good work. make sure that you seal the enclosure. you would not want a water ingress point
  17. Scott Danforth

    Spreading Manure, again

    would like to see the prop tested in the real world. maybe down here in the ICW where the channels move with every tide and there are submerged boats that you can hit.
Top