Search results

  1. demarko210

    Removing old water lines

    Chris I tried some purlple power after i created the post yesterday it did not work. I dont think superclean will either.
  2. demarko210

    Removing old water lines

    I know it was tape but i didnt know what to call it. I just said the water line. I will try your method and let you know.
  3. demarko210

    Removing old water lines

    What would be the best way to remove these old lines of the hull? Wet sand, degreaser... Thanks
  4. demarko210

    Two year old fuel

    Rainbow could be coming from the lower unit may have a leak.
  5. demarko210

    1st Boat/First Thread/First Everything lol. Need help

    I think this style boat is called a deck boat. Ive seen some on you tube that go to fast and come down on a nice wave will take water over the bow. Make sure those bilge pumps work. Pontoon boats are the same. Not to scare you I am a new boater in a way just have not put the time in on my...
  6. demarko210

    High Idle (2900rpm) - 1988 l6 115hp Mercury

    Just from the sound of the motor in the video, it does not sound like the engine is idling at 2900. It sounds to me to be idling just fine. I would agree that the tach is off. I had a tach like this when i had my inline 6. I would add a adhesive sticky that came with the tach to the fly wheel...
  7. demarko210

    Treated Lumber for Bunk Boards

    Never updated the boards on my trailer but considered doing it on my last boat. Would using A/B plywood stacked to the size of the 2 x 4 and wrapping it chop strand mat or 1708 be too much for this?
  8. demarko210

    Two year old fuel

    I purchased this item from Amazon to pull the gas out of my tank. I also connected a fuel water separator to the line encase there was water in the fuel after I store the boat for the season. Its just a standard fuel pump and gas line. I let it pump for about 30 min. 15 minutes then i let it...
  9. demarko210

    1st Boat/First Thread/First Everything lol. Need help

    Nice boat, the one thing i do not like about that style boat is that they take on water over the bow a lot. That is if its rough out on the water. I think these style boats are great for the lakes and rivers. Enjoy and good luck boating.
  10. demarko210

    Enclosure, 1984 Seaswirl Sierra Cuddy

    Are you talking about a isinglass? These are usually custom made unless you purchase a new boat that came with one. They can be expensive, I was pricing a hardtop for this boat at about $4000 and asked the guy about making the isinglass. That was an extra $2000.
  11. demarko210

    Raw water pump and tubing

    that is correct thanks Mike
  12. demarko210

    Raw water pump and tubing

    Will do wanted to be sure size does matter. Thanks
  13. demarko210

    Raw water pump and tubing

    There is no fuse attached to the device unless its inside the motor. The instructions stated to use a 18 amp fuse, I was asking if I should use a 20 or 15 since i can not find a 18 amp blade fuse.
  14. demarko210

    Raw water pump and tubing

    I purchased a new seaflow 33 water pump for my raw water. The barb connection is 3/4 inch and the tubing i purchase is 3/4 inch ID. WHen i attach the barb to the tubing it slide in and out without adding the clamps to it. My question is, is the correct size tubing for the barb or am I going...
  15. demarko210

    Rehab SportCraft 222 1983 deep V hull cuddy walkaround

    That was the guy that I sold the boat to that has cancer. I was just showing the link of what the guy did after me. I still have the second boat the sea fox. Getting ready to take it out in another week. Just finished hooking up my NMEA display today.
  16. demarko210

    Rehab SportCraft 222 1983 deep V hull cuddy walkaround

    hey KC just checking up on you and your work. Hope everyone is well! Check out this link of the Grady. Old timer finished the work and listed it for sale.
  17. demarko210

    Flickering cabin light when turning on item from switch panel.

    Also the item that i turned on was the fresh water washdown pump. The flicker is only when the new circuit is switched.
  18. demarko210

    Flickering cabin light when turning on item from switch panel.

    I am not sure what size the ground wire is. I have not really looked for the ground wire as it hidden some place. I will locate it. I ran over to the boat this morning after reading your message. What I found when i connect the volt meter. The light on then turning on another circuit the volts...
  19. demarko210

    Flickering cabin light when turning on item from switch panel.

    I am installing my switch panel that I removed over the winter to replace some switches and breakers. What I notice as I was connecting items one by one and powering them on with the cabin light switched (also a item on the switch panel) to the on position is a flickering every time I turn on a...
  20. demarko210

    03 150 Saltwater EFI thermostat housing

    Fixed it with a bolt from Home Depot. Mercury called for M8 X 25 used a M8 X 30 and it fasten right up. I may take the bolt and paint it to keep the corrosion down. The gunk around the top is the Permatex No. 3 i was using. Moving on to the electronic switches and I will be sailing! Thanks again.
Top