Search results

  1. alldodge

    Tinkering on the 4.3l this winter...

    Other then the Merc racing motors, no factory motor is even close to reversion @Scott Danforth should help with the rockers
  2. alldodge

    AD41 loss of power to instrument panel

    Or fuse/breaker blew
  3. alldodge

    1985 Sleekcraft Diplomat Openbow Mercruiser 260 Restoration

    Boats less than 20 feet have to have one, those above that do not
  4. alldodge

    1996 Yamaha WRA650U, idles fine, but will not rev up.

    Good luck Sir
  5. alldodge

    1996 Yamaha WRA650U, idles fine, but will not rev up.

    Being a carb and it won't rev I would look at fuel delivery and timing. While some ignition systems have limiters, most carb models do not Normally a carb will clog up at idle and be even worst at higher rpm, but it might be flooding or main jests are clogged I might be doing you a dis-service...
  6. alldodge

    1996 Yamaha WRA650U, idles fine, but will not rev up.

    TPS Throttle Position Sensor ok, this is a carberated model?
  7. alldodge

    Lopi Travis Industries Radiant Plus Gas Logs no Thermostat Control

    Have an issue for 2 seasons with a propane vented gas log set. Posting this so others might find and help out. Found one thread which had same issue but there was no conclusion as what was the fix. Issue: The fireplace works fine in manual control, but switch to Auto and flame increases and...
  8. alldodge

    1969 MC-1 outdrive???

    In post 3 select the link Select Bell Housing box, the find items 15 bellows U joint 19 exhaust bellows or exhaust tube Shift cable boot is 74639A2
  9. alldodge

    1996 Yamaha WRA650U, idles fine, but will not rev up.

    Full disclosure never work on a wave runner, seadoo guy here Don't see it being rev limiter because it idles good and doesn't even start to rev up. Do wonder with the throttle opening at idle the motor should cough and dies of something. The TPS is a variable resistor, use a voltmeter and...
  10. alldodge

    ignition switch power

    Welcome
  11. alldodge

    1996 Yamaha WRA650U, idles fine, but will not rev up.

    Welcome When the throttle is increased, does the cable move the the the throttle body?
  12. alldodge

    1966 MFG Rebuild

    Looks like adhesive was used between the two
  13. alldodge

    1969 MC-1 outdrive???

    Don't know which motor but here is one under the 165 https://www.mercruiserparts.com/165-1978-1981-4890460-up
  14. alldodge

    1969 MC-1 outdrive???

    Welcome It is a MC-1 See our Stickes
  15. alldodge

    NOCO LifeP04 in lawn mower

    Received new Battery under warranty
  16. alldodge

    I messed up my 35hp Merc.

    It's a venturi port which sucks fuel in from carb when motor is running
  17. alldodge

    I messed up my 35hp Merc.

    Don't know for sure but are in the right place for the venturi
  18. alldodge

    Mercruiser 165's First Engine Align, Having Trouble

    ok, about what I thought the hatch would be open, and also why a cherry picker could not be used. Could use wood across the gunnels to hoist also
  19. alldodge

    Baja 2005 202 Islander with a 5.0 Merc Crusier

    Welcome, no need to shout Get a piece of flat aluminum stock from the hardware store, at least 1.5 inch wide. Disconnect or cut wires going to old bilge pump. Bend flat stock so it gets right beside the old pump and the other ends lays against a stringer or bulk head. Attach new pump to end...
  20. alldodge

    Mercruiser 165's First Engine Align, Having Trouble

    Install front mounts on motor mounts Pickup front of motor (in the center) just enough for mounts to be off the deck. Lower motor down and mark mounting holes. Install lag screws Now lift the motor off the mounts and start the leveling as mentioned previously Guess I'll need a pic to see the...
Top