Search results

  1. tashasdaddy

    89 force 50, this is what i've found

    marine power, no serial # m # on top of block K123057, # flywheel 3000A # carb 684061. need coils # 380 and blue power pack no # , starter no#. cold dry compression 3 strokes 75-80 each. lower unit no water. need best part source.
  2. tashasdaddy

    snap,crackle,pops, sizzle, sizzzle.UPDATE

    same boat i posted about last week. 1999 VP 5.7 sx drive. last week shut down, no oil all in bilge, certified mach said hole i oil pan, after the previous week, pulling engine servicing outdrive, pulling engine,replacing starter, exhaust mainfold, water pump, this week replaced oil pan...
  3. tashasdaddy

    are there that few 89 50's around

    having extrerme problems finding any info on this engine, or any marine power forces. and parts seem just as rare.
  4. tashasdaddy

    1989 50HP Force what have i done

    just purchase 17 Alum. boat, w/ this engine. know nothing about force. need manual, starter, plug wires key. i bought the boat , but if i can get it running will use this engine for awhile. i'm a johnny/rude man. best place for parts, and manual, what to look out for with this one...
  5. tashasdaddy

    should they have missed this.

    sister's & bro & law's 1999 5.7 VP. starter went out, hard to get to went to shop, they pulled engine to get to starter, changed mainfolds, serviced outdrive, oil change. the whole 9 yards. got boat back, went to lake, crused for 3 hours, engine shuts down, won't start, open engine...
  6. tashasdaddy

    evr say DOH!! 55 15 hp rude

    have never had a problem, went to start yesterday in drum, no start, so i do the trinity, spark good compression 110 both, plugs dry. shoot a couple of drop of premix in cylinder, fire off. so i remove cover, and an going to go for the carb, ( had just replaced 2 line hose to tank last...
  7. tashasdaddy

    JB can you post "awakening a sleeping outboard"

    so i can save it. got a couple of people that need it, with the faq down.
  8. tashasdaddy

    38 Evinrude 2.8 H.P. info. please

    if not mistaken it is a 16-1 gas to oil.
  9. tashasdaddy

    oil to gas mixture.....HELP!

    50-1 6 gallons to 1 16 ounces of tcw 3 oil.
  10. tashasdaddy

    1957 71/2 Johnson Seahorse Overheating

    put it back in the garbage can and fill it to where the water is 1/2 way up the engine shaft the deeper the better. the pump has to be below water level to prime. if it doesn't pump maxrules.com and laingsoutboards.com have the water pump kits.
  11. tashasdaddy

    what is the reason volvo,omc, mercruiser

    i 'v noticed there seems to be numerous post about omc's, and mercruisers, and few about Volvo's..the omc's i understand, but why more mercruisers, are there just that many more out there ?or are the volvo's that much more dependable? or do mercruiser owners work on their own, and VP send it to...
  12. tashasdaddy

    71 100ESL Johnson Safety switch help

    find out the reason it is getting hot. if you by pass you're going to burn it up. go to the engine faq and read awakening a sleeping outboard. it sounds like the power pack or coils are getting hot and failing. do you havae spark on all cylinders when it does this.
  13. tashasdaddy

    40hp johnson

    timing usually causes backfire. check the center of you flywheel. there is a groove with a metal key. if this is not perfectly lined up the flywheel had to be pulled (special process) and a new key installed. the proper compressio is not published by the MFG. anything over 100psi and with...
  14. tashasdaddy

    Evinrude 120hp

    model # please .
  15. tashasdaddy

    Mercury 60 won't run at mid throttle

    it is normal for the bulb to be soft, while the engine is running. if it is collasping, there is a blockage. could be linc n sinc, or dirty carbs, pushing the choke points to this. go to engine faq and read linc n sinc, decarb, carb rebuild.
  16. tashasdaddy

    shifting problem

    your idle is either too high, or you cable are binding, or going bad. docking should be done very slow, reverse is not a brake. and no you should not go the reverse when going fast, you will take out the lower unit. do you shift into reverse in the car going fast?
  17. tashasdaddy

    1996 Johnson 60 hp outboard

    is the engine running hot. did you notice the pee stream. check compresssion first before spending any money. no alarm?
  18. tashasdaddy

    propeller freewheels

    either the shift shaft is not working, the prop is completely spun, or the lower unit is shot, or the cable is shot. imho. are you using the control to shift have you tried disconnecting the control at the motor and shifting.
  19. tashasdaddy

    manual for 1965 evinrude 6 horse fisherman?

    brp-evinrude, parts & access. lower right there is literture, click there and it will take you the the site for the factory service manual. which is best , a little pricey, but worth it. it uses 50-1 fuel mixture and plugs are J4C gapped at .030
  20. tashasdaddy

    trailering suzuki 90hp

    what is best is to trailer it with a motor support. don't depend on the trim and tilt as this adds stress to the system and the transom. some of my boats have plenty of clearance between the road and the foot, others have to be supported for proper clearance. all you do when trailering with...
Top